(1KS1,1KS2)
AMM 73-25-34-400-040 Installation of the Engine Interface Unit (EIU)
(1KS1,1KS2)
AMM 73-25-34-710-043 Operational Test of the Engine Interface Unit
ASM 73-25/09
3. Fault Confirmation
__________________
A. Do the operational test of the engine interface unit through the CFDS (Ref. AMM TASK 73-25-34-710-043).
4. Fault Isolation
_______________
A. If the test gives the maintenance message CHECK ZONE CONT 8HK/EIU 2 CIRCUIT:
- replace the CONT-ZONE TEMPERATURE (8HK) (Ref. AMM TASK 21-63-34-000-001) and (Ref. AMM TASK 21-63-34-400-001).
(1) If the fault continues:
- replace the EIU-2 (1KS2) (Ref. AMM TASK 73-25-34-000-040) and (Ref. AMM TASK 73-25-34-400-040).
(2) If the fault continues:
- do a check and repair the wiring from the EIU-2 (1KS2) to the zone temperature controller (8HK) pin AB/1E to pin AB/1K (Ref. ASM 73-25/09).
B. Do the test given in Para. 3.A.
F 『 EEFF : ALL E ∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 225
E E Feb 01/98 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
TASK 73-25-00-810-863
Failure of the N2 Higher than the Minimum TO Discrete Output on the EIU 1
1. Possible Causes
_______________
- CONTROLLER-PACK 1 TEMP (7HH)
- EIU-1 (1KS1)
- CONT-AIR COND SYSTEM 1 (47HH)
- wiring from the EIU-1 (1KS1) to the pack 1 temperature controller (7HH)
- wiring from the EIU-1 (1KS1) to the pack 1 temperature controller (47HH)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 21-61-34-000-001 Removal of the Pack Controller (7HH, 27HH)
AMM 21-61-34-000-002 Removal of the Air-Conditioning System Controller
(47HH, 57HH)
AMM 21-61-34-400-001 Installation of the Pack Controller (7HH, 27HH)
AMM 21-61-34-400-002 Installation of the Air-Conditioning System
Controller (47HH, 57HH)
AMM 73-25-34-000-040 Removal of the Engine Interface Unit (EIU)
(1KS1,1KS2)
AMM 73-25-34-400-040 Installation of the Engine Interface Unit (EIU)
(1KS1,1KS2)
AMM 73-25-34-710-043 Operational Test of the Engine Interface Unit
ASM 73-25/09
3. Fault Confirmation
__________________
A. Do the operational test of the engine interface unit through the CFDS (Ref. AMM TASK 73-25-34-710-043).
4. Fault Isolation
_______________
R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-299, 301-302,
A. If the test gives the maintenance message CHECK PACK CONT 7HH EIU 1 CIRCUIT:
- replace the CONTROLLER-PACK 1 TEMP (7HH) (Ref. AMM TASK 21-61-34-000-001) and (Ref. AMM TASK 21-61-34-400-001).
(1) If the fault continues:
- replace the EIU-1 (1KS1) (Ref. AMM TASK 73-25-34-000-040) and (Ref. AMM TASK 73-25-34-400-040).
F 『 EEFF : ALL E ∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 226
E E May 01/05 E E ECES
E
F 『
E C F M E
E E
E 56 E
E E
(2) If the fault continues:
- do a check and repair the wiring from the EIU-1 (1KS1) to the pack1 temperature controller (7HH) pin AB/1G to pin AA/10B (Ref. ASM 73-25/09).
R **ON A/C 106-149, 303-399, 401-499,
A. If the test gives the maintenance message CHECK PACK CONT 7HH/EIU1 CIRCUIT:
NOTE : CONT-PACK (7HH) has been replaced by AIR COND SYS 1 (47HH) due to
____
a modification of the Air Conditioning System.
- replace the CONT-AIR COND SYSTEM 1 (47HH) (Ref. AMM TASK 21-61-34-000-002) and (Ref. AMM TASK 21-61-34-400-002).
(1) If the fault continues:
- replace the EIU-1 (1KS1) (Ref. AMM TASK 73-25-34-000-040) and (Ref. AMM TASK 73-25-34-400-040).
(2) If the fault continues:
- do a check and repair the wiring from the EIU-1 (1KS1) to the pack1 temperature controller (47HH) pin AB/1G to pin AB/3C (Ref. ASM 73-25/09).
**ON A/C ALL
B. Do the test given in Para. 3.A.
F 『 EEFF : ALL E ∞∞73-25-00∞∞∞∞∞∞∞∞∞∞Page 227
E E Aug 01/05 E E ECES
E
F 『
E C F M E
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 发动机燃油和控制 2(44)
