「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-13-00∞∞∞∞∞∞∞∞∞∞Page 218
Nov 01/03 CES
R - remove the jumper wire between pins F and G of the plug
R 2878VC
R - replace the IND LT-SLIDE ARMED, AFT R DOOR (3WN2) (Ref.
R AMM TASK 52-73-21-000-002) and (Ref. AMM TASK 52-73-21-
400-002).
R
R * On the Door/Oxy page, if the CABIN indication comes
R into view amber:
R - remove the jumper wire between pins F and G of the plug
R 2878VC
R - connect the plug 2878VC to the indicator light (3WN2)
R - do a check for a ground signal at pin C of the handle
R proximity switch (17WV2) (Ref. ASM 31-54/05).
R
R ** If there is no ground signal:
R - repair the wiring from the pin C of the handle proximity
R switch (17WV2) to the ground terminal (Ref. ASM 31-54/05)
R
R ** If there is a ground signal:
R - do a check of the wiring between:
R *** the handle proximity switch (17WV2) pin B and the
R indicator light (3WN2) pin F,
R *** the indicator light (3WN2) pin G and the hook
R proximity switch (15WV2) pin C,
R *** the hook proximity switch (15WV2) pin B and the
R SDAC-1(2) pin AD/11H (Ref. ASM 31-54/02) and (Ref. ASM
31-54/05).
R - repair the wiring as necessary.
R 3_ If the fault continues:
R - replace the SDAC-1 (1WV1) (Ref. AMM TASK 31-55-34-000-001)
R and (Ref. AMM TASK 31-55-34-400-001).
R 4_ If the fault continues:
R - replace the SDAC-2 (1WV2) (Ref. AMM TASK 31-55-34-000-001)
R and (Ref. AMM TASK 31-55-34-400-001).
R
B. Test
(1) On the ECAM control panel:
- push the DOOR key to get the DOOR/OXY page.
(2) Make sure that the CABIN indication comes into view green on the ECAM system page.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-13-00∞∞∞∞∞∞∞∞∞∞Page 219
Nov 01/03 CES 5. Close-up
________
A. Put the aircraft back to its initial configuration.
(1) On the ECAM control panel, set the LOWER DISPLAY and the UPPER DISPLAY potentiometers to OFF.
(2) De-energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-862-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-13-00∞∞∞∞∞∞∞∞∞∞Page 220
Nov 01/03R
CES
TASK 52-13-00-810-805
No SLIDE Indication on the DOOR/OXY Page when the R Aft Escape Slide Handle is
in the SLIDE ARMED Position
1. Possible Causes
_______________
- IND LT-SLIDE ARMED, AFT R DOOR (3WN2)
- IND LT-SLIDE ARMED, R EMER EXIT (2WN2)
- IND LT-SLIDE ARMED, FWD R DOOR (1WN2)
- PROX SW-HANDLE, R AFT ESC SLIDE (7WN2)
- RELAY-PWR SPLY SWITCHOVER (12WN)
- wiring from the connector (7WN2-A) to the indicator light (3WN2)
- wiring from the indicator light (3WN2) to the SDAC-1(2) (1WV1(2)) 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：A320 Trouble Shooting Manual 排故手册 舱门 DOORS(51)
