- remove the jumper wire between pins B and C of the connector (11WV1-A)
- connect the connector of the hook proximity switch (11WV1)
- disconnect the plug of the indicator light (1WN1)
- install the jumper wire between pins F and G of the plug 2875VC (Ref. AWM 52-73-04)
- do the test given in Para. 3.C.
* On the Door/Oxy page, if the CABIN indication comes into view green:
- remove the jumper wire between pins F and G of the plug 2875VC
- replace the IND LT-SLIDE ARMED, FWD L DOOR (1WN1) (Ref. AMM TASK 52-73-21-000-001) and (Ref. AMM TASK 52-73-21-400-001).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-11-00∞∞∞∞∞∞∞∞∞∞Page 217
Aug 01/05 CES * On the Door/Oxy page, if the CABIN indication comes into view amber:
- remove the jumper wire between pins F and G of the plug 2875VC
- connect the plug 2875VC to the indicator light (1WN1)
- do a check for a ground signal at pin C of the handle proximity switch (13WV1) (Ref. ASM 31-54/05).
** If there is no ground signal:
- repair the wiring from the pin C of the handle proximity switch (13WV1) to the ground terminal (Ref. ASM 31-54/05).
** If there is a ground signal:
- do a check of the wiring between: *** the handle proximity switch (13WV1) pin B and the indicator light (1WN1) pin F, *** the indicator light (1WN1) pin G and the hook proximity switch (11WV1) pin C, *** the hook proximity switch (11WV1) pin B and the SDAC-1(2) pin AA/11A (Ref. ASM 31-54/02) and (Ref. ASM 31-54/05).
- repair the wiring as necessary.
3 If the fault continues:
_
- replace the SDAC-1 (1WV1) (Ref. AMM TASK 31-55-34-000-001) and (Ref. AMM TASK 31-55-34-400-001).
4 If the fault continues:
_
- replace the SDAC-2 (1WV2) (Ref. AMM TASK 31-55-34-000-001) and (Ref. AMM TASK 31-55-34-400-001).
B. Test
(1) On the ECAM control panel:
- push the DOOR key to get the DOOR/OXY page.
(2) On the DOOR/OXY page:
- make sure that the CABIN indication comes into view green.
5. Close-up
________
A. Put the aircraft back to its initial configuration.
(1) On the ECAM control panel, set the LOWER DISPLAY and the UPPER DISPLAY potentiometers to OFF.
(2) De-energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-862-002).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-11-00∞∞∞∞∞∞∞∞∞∞Page 218
Aug 01/05R CES
TASK 52-11-00-810-805
No SLIDE Indication on the DOOR/OXY Page when the R Forward Escape-Slide Handle is in the SLIDE ARMED Position
1. Possible Causes
_______________
- IND LT-SLIDE ARMED, FWD R DOOR (1WN2)
- PROX SW-HANDLE, R FWD ESC SLIDE (4WN2)
- RELAY-PWR SPLY SWITCH OVER (12WN)
- wiring from the proximity switch (4WN2) to the indicator light (1WN2)
- wiring from the indicator light (1WN2)
- wiring from the proximity switch (4WN2) pin A/C to the ground terminal
- wiring from the indicator light (1WN2) to the relay (12WN)
- wiring from the relay (12WN) to the circuit breaker (13WN)
- wiring from the relay (12WN) to the circuit breaker (15WN)
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
AMM 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power AMM 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
from the External Power AMM 31-60-00-860-001 EIS Start Procedure AMM 52-71-00-820-002 Adjustment of the Proximity Switches (4WN1, 4WN2,
7WN1, 7WN2, 13WV1, 13WV2, 17WV1, 17WV2) of the Passenger/Crew Doors with the CHECKING TOOL-DOORS
AMM 52-71-00-820-002 Adjustment of the Proximity Switches (4WN1, 4WN2, 7WN1, 7WN2, 13WV1, 13WV2, 17WV1, 17WV2) of the Passenger/Crew Doors with the ECAM DU.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320 Trouble Shooting Manual 排故手册 舱门 DOORS(29)
