• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-03-29 09:25来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 1. Possible Causes
_______________
 - IND LT-SLIDE ARMED, FWD L DOOR (1WN1)

 - wiring from the proximity switch (13WV1) to the indicator light (1WN1)

 - wiring from the proximity switch (13WV1) pin C to the ground

 - RELAY-PWR SPLY SWITCHOVER (12WN)

 - wiring from the relay (12WN) to the indicator light (1WN1)

 - C/B-EIS/SLIDES/ARM AND WARN/FLT (15WN)

 - wiring from the circuit breaker (15WN) to the relay (12WN)

 - wiring from the circuit breaker (15WN) to the indicator light (1WN1)


 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------
REFERENCE DESIGNATION
 -------------------------------------------------------------------------------
AMM 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power AMM 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied
 from the External Power
R AMM 25-62-44-000-002 Removal of the Escape-Slide Pack-Assembly
R AMM 25-62-44-400-001 Installation of the Escape-Slide Pack-Assembly AMM 52-10-00-860-001 Special Precautions before Work on the Passenger/Crew Door AMM 52-10-00-860-002 Special Precautions after Work on the Passenger/Crew Door AMM 52-73-21-000-001 Removal of the SLIDE ARMED Indicator-Light (1WN1, 1WN2) of the FWD Passenger/Crew Door AMM 52-73-21-400-001 Installation of the SLIDE ARMED Indicator-Light (1WN1, 1WN2) of the FWD Passenger/Crew Door ASM 31-54/05 ASM 52-73/01
 3. Fault Confirmation
__________________
 A. Aircraft Maintenance Configuration
 (1) Energize the aircraft electrical circuits
 (Ref. AMM TASK 24-41-00-861-002).


 (2) Disarm the percussion system of the door damper and emergency operation cylinder (Ref. AMM TASK 52-10-00-860-001).

 (3) Remove the escape slide or escape slide/raft pack assembbly (Ref. AMM TASK 25-62-44-000-002).

 


 B. Make sure that this(these) circuit breaker(s) is(are) closed: -------------------------------------------------------------------------------
PANEL ------ DESIGNATION ------------------------------------ ------------------ IDENT. LOCATION-------------------
121VU EIS/SLIDES/ARM AND WARN/GND  13WN  P10
 C. Test
 ------------------------------------------ACTION  ------------------RESULT -------------------

-------------------------------------------------------------------------------
Open the left forward Make sure that the SLIDE ARMED
 passenger/crew-door with the escape indicator-light of the forward left
 slide handle in the ARMED position. passenger/crew door is not on.
 4. Fault Isolation
_______________
 A. If the test confirms the fault:
 - do a check of the circuit breaker 15WN status (Ref. ASM 52-73/01).
 (1) If the circuit breaker is closed:
 - do a check for 28VDC at the indicator light (1WV1) pin A (Ref. ASM 52-73/01).
 (a) If there is 28VDC:
 - replace the IND LT-SLIDE ARMED, FWD L DOOR (1WN1), (Ref. AMM TASK 52-73-21-000-001) and (Ref. AMM TASK 52-73-21-400-001).
 1 If the fault continues:
_
 - do a check for a ground signal at pin C of the proximity switch (13WN1) (Ref. ASM 31-54/05).
 a If there is a ground signal:
_
 - do a check and repair the wiring from the proximity switch (13WV1) to the indicator light (1WN1) pin B to pin F (Ref. ASM 31-54/05) and (Ref. ASM 52-73/01).
 b If there is no ground signal:
_
 - repair the wiring from the proximity switch (13WV1) pin C to the ground, (Ref. ASM 31-54/05).
 (b) If there is no 28VDC:
 - do a check for 28VDC at pin A/B1 of the relay (12WN) (Ref. ASM 52-73/01).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞52-11-00∞∞∞∞∞∞∞∞∞∞Page 236
 Nov 01/03R CES


 1_ If there is 28VDC:
 - replace the RELAY-PWR SPLY SWITCHOVER (12WN), (Ref. ASM 52-
73/01).

 a If the fault continues:
_
 - do a check and repair the wiring from the relay (12WN) to the indicator light (1WN1) pin A/B2 to pin A (Ref. ASM 52-73/01).
 2 If there is no 28VDC:
_
 - do a check of the wiring from the circuit breaker (15WN) to the relay (12WN), pin 2 to A/B1.
 a If there is continuity:
_
 - replace the C/B-EIS/SLIDES/ARM AND WARN/FLT (15WN), (Ref. ASM 52-73/01).
 b If there is no continuity:
_
 - repair the wiring from the circuit breaker (15WN) to the relay (12WN) pin 2 to pin A/B1 (Ref. ASM 52-73/01).
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320 Trouble Shooting Manual 排故手册 舱门 DOORS(36)