- do the Xloading procedure of the DMC3 (1WT3) (Ref. AMM TASK 31-60-00-610-003)
(b) If the software P/N is the same:
- check and repair the engine pin programming of the DMC3 (1WT3), on pins AE-5C; AE-5D; AE-5E; AE-5G and AE-5H (Ref. AWM 31-61-30)
5. Close-up
________
A. Close-up
- do the EIS Stop procedure (Ref. AMM TASK 31-60-00-860-002).
DMC VERSION INCONSISTENCY on all the DU's
1. Possible Causes
_______________
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 31-60-00-610-003 X LOADING Procedure of the DMC1 AMM 31-60-00-610-004 X LOADING Procedure of the DMC2 AMM 31-60-00-610-005 X LOADING Procedure of the DMC3 AMM 31-60-00-740-011 LRU Identification Check AMM 31-60-00-860-001 EIS Start Procedure AMM 31-60-00-860-002 EIS Stop Procedure AWM 31-61-28 AWM 31-61-29 AWM 31-61-30
3. Fault Confirmation
__________________
A. Job Set-up
(1) Do the EIS start procedure (Ref. AMM TASK 31-60-00-860-001).
4. Fault Isolation
_______________
A. If the DMC VERSION INCONSISTENCY indication is shown on all the DU's:
- do the LRU identification check (Ref. AMM TASK 31-60-00-740-011).
(1) Make sure that the software P/N of each DMC is the same that the P/N of the set of floppy disks
(a) If the software P/N is different:
- do the Xloading procedure of the DMC1 (1WT1) (Ref. AMM TASK 31-60-00-610-003)
- do the Xloading procedure of the DMC2 (1WT2) (Ref. AMM TASK 31-60-00-610-004)
- do the Xloading procedure of the DMC3 (1WT3) (Ref. AMM TASK 31-60-00-610-005)
(b) If the software P/N is the same:
- check and repair the engine pin programming of the DMC's, on pins AE-5C; AE-5D; AE-5E; AE-5G and AE-5H (Ref. AWM 31-61-28), (Ref. AWM 31-61-29) and (Ref. AWM 31-61-30).
5. Close-up
________
A. Close-up
- do the EIS Stop procedure (Ref. AMM TASK 31-60-00-860-002
