%
Doc # 6.02.01 Page 201
Rev. 4 09 Jan 2003
73-01-00
AMM
% Fuel Inlet Fuel Return
Mounting Bracket
%
%
%
%
%
%
% % % Figure 2: Engine Fuel Filter Installation %
73-01-00
Engine Fuel and Control
AMM
%
%
%
%
%
%
%
%
%
%
%
%
% B. Replace the Fuel Filter Element %
Detail Steps/Work Items Key Items/References
(1) Release the bowl from the filter assembly: S Unscrew from top part of filter assembly.
(2) Remove the old filter element. Look for unwanted material and water in the filter bowl and on the element. If you find unwanted material, examine the airplane fuel system to find the source.
(3) Install a new filter element (TAE part no. 02-7310-0474001). Use a new seal.
(4) Attach the filter bowl to the filter body: S Screw onto top part of filter assembly.
%
Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003
73-01-00
DA 40 Series
AMM
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% C. Install the Engine Fuel Filter %
Detail Steps/Work Items Key Items/References
WARNING: YOU MUST MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO WORK ON THE ENGINE. IF THE PROPELLER TURNS IT CAN CAUSE INJURY TO PERSONS.
(1) Make sure that the engine is safe: S Set the ELECTRIC MASTER key switch to OFF. S Set the ENGINE MASTER switch to OFF. S Set the power lever to IDLE.
(2) Put the fuel filter in position in the airplane.
Tighten the 2 worm-drive clamps that attach the filter to the mounting bracket.
(3) Connect the 4 fuel hoses at the fuel filter. Tighten the inlet and return hoses. Torque: 17 - 22 Nm (12.5 - 16.2 ft.lb).
(4) Bleed the fuel distribution system. Refer to Section 28-21.
(5) Do an engine run-up. Refer to Section 71-01. Look for fuel leaks in the area of the fuel filter.
Note: Starting may take longer than usual as the engine fuel system bleeds fully.
(6) Install the engine cowlings. Refer to Section 71-11.
%
Page 204 Doc # 6.02.01 09 Jan 2003 Rev. 4
73-01-00
Ignition
AMM
CHAPTER 74
IGNITION
Doc # 6.02.01 Page 1
Rev. 4 09 Jan 2003
74-TITLE
AMM
Intentionally left blank
74-TITLE
Ignition
AMM
TABLE OF CONTENTS
CHAPTER 74
IGNITION
1.
General ..............................................1
2.
Description............................................1
3.
Ignition System Components ..............................3
4.
Operation.............................................6
Trouble Shooting
1. General ............................................101
Maintenance Practices
1.
General ............................................201
2.
Remove/Install the Ignition Switch ........................201
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:钻石40飞机维护手册 DA 40 SERIES AMM 5(57)