% A. Equipment %
Item Quantity Part Number
Hoist. 1 Commercial.
Engine sling. 1 Commercial.
Engine stand. 1 Commercial.
Tail trestle. 1 Commercial.
%
Doc # 6.02.01 Page 201
Rev. 4 09 Jan 2003
71-01-00
AIRCRAFT AMM
%
%
%
%
Oil Filter Housing
%
%
Manifold Temperature % Manifold Pressure Sensor
Connection
%
%
%
Intercooler
%
%
%
Oil Temperature % Sensor %
Oil Filler
%
Coolant Temperature
%
Sensor
%
%
Fuel Return
%
%
%
%
%
Combined
%
Oil Pump
% % % Oil Return from
Turbo-Charger
%
%
Crankshaft 2 Sensor
%
%
%
Oil Pre-Separator
%
%
%
Oil Return from Oil Radiator
Oil Supply to Oil Radiator
Overboard Vent
Oil Separator
Oil Return Line
Starter Motor Alternator Oil Radiator Breather Line
% Figure 2: TAE 125 Diesel Engine Components %
Page 202 Doc # 6.02.01 09 Jan 2003 Rev. 4
71-01-00
DA 40 Series
Power Plant
AMM
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% B. Remove the Engine %
Detail Steps/Work Items Key Items/References
(1) Read the engine event log. Refer to Section 72-01.
WARNING: MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO ANY WORK ON THE PROPELLER. IF THE ENGINE IS TURNED, THE PROPELLER CAN CAUSE INJURY OR DEATH.
(2) Set the emergency fuel valve to OFF.
(3) Make sure that the engine is safe: S Set all switches to OFF. S Set the power lever to IDLE.
(4) Remove the engine cowlings. Refer to Section 71-11.
(5) Disconnect the airplane main battery. Refer to Section 24-34.
(6) Remove the propeller. Refer to Section 61-11.
(7) Drain the coolant system. Refer to Section 75-01.
(8) Drain the engine oil. Refer to Section 72-01.
(9) Remove the coolant radiator together with the coolant tank. Refer to Section 75-01.
(10) Disconnect the breather line. At the oil pre-separator.
(11) Disconnect the oil hoses between the oil radiator and the engine at the oil filter housing. Use a suitable container to catch the oil in the tubes.
(12) Disconnect the electrical cables from the starter motor. S Disconnect the two control cables at the solenoid. S Disconnect the main supply cable at the solenoid. S Release all clips and ties holding the cables to the engine. Do not remove clips and ties on the engine mount.
(13) Disconnect the electrical cables on the alternator. S Release all clips and ties holding the cables to the engine.
Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003
71-01-00
AIRCRAFT
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:钻石40飞机维护手册 DA 40 SERIES AMM 5(20)