• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-05-24 14:59来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

If you have the trouble detailed in the Trouble column read across to the Possible Cause column. Then do the repair given in the Repair column.
Trouble  Possible Cause  Repair 
Engine vibration.  Damaged shock mounts.  Replace the shock mounts. 
Engine does not produce full power.  Engine air inlet blocked.  Examine air inlet. Examine/Replace the air filter. 

Doc # 6.02.01 Page 101
Rev. 4 09 Jan 2003

71-00-00
AMM

Intentionally left blank
71-00-00
Power Plant
AMM

Maintenance Practices
1. General
These maintenance practices tell you how to remove/install the engine. These maintenance practices also tell you how to remove/install the engine and engine mount together.
WARNING:  DO NOT STAND WITHIN THE DANGER AREA OF THE PROPELLER. IF THE ENGINE STARTS, THE PROPELLER CAN CAUSE DEATH OR INJURY TO PERSONS. 
WARNING:  YOU MUST MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU TURN THE PROPELLER. MAKE SURE THAT THE IGNITION SWITCH IS SET TO “OFF” AND THAT THE SPARK-PLUG-CABLES ARE DISCONNECTED FROM THE SPARK PLUGS. SET THE THROTTLE TO “IDLE” AND THE MIXTURE CONTROL TO “LEAN CUT-OFF”. 
WARNING:  DO NOT GO BELOW THE ENGINE WHEN YOU LIFT THE ENGINE WITH THE HOIST. THE HOIST CAN FAIL. THIS CAN CAUSE DEATH OR INJURY TO PERSONS. 
WARNING:  DO NOT GET OIL ON YOU. OIL CAN CAUSE SKIN DISEASE. 
WARNING:  DO NOT GET FUEL ON YOU. FUEL CAN CAUSE SKIN DISEASE. DO NOT ALLOW FIRE OR SPARKS NEAR FUEL. FUEL BURNS AND BURNING FUEL CAN CAUSE INJURY TO PEOPLE AND DAMAGE TO EQUIPMENT. 
CAUTION:  YOU MUST ATTACH CAPS TO HOLES/PIPES WHEN YOU REMOVE THE ENGINE. IF YOU DO NOT DO THIS, CONTAMINATION CAN ENTER THE HOLES/PIPES. THIS CAN CAUSE BLOCKAGE TO THE AIRPLANE SYSTEMS. 

Doc # 6.02.01 Page 201
Rev. 4 09 Jan 2003

71-00-00
AMM


Oil Hose to Front of Oil Cooler
Figure 2: Connections at the Rear of the Engine
71-00-00
Power Plant
AMM

2. Remove/Install the Engine (without the Engine Mount)
A. Equipment
Item  Quantity  Part Number 
Hoist.  1  Commercial. 
Engine sling.  1  Commercial. 
Engine stand.  1  Commercial. 
Airplane jacks.  3  Commercial. 
Nose trestle.  1  Commercial. 
Wing trestles.  2  Commercial. 

B. Remove the Engine
Detail Steps/Work Items  Key Items/References 
(1)  Lift the airplane on jacks and make the airplane level.  Refer to Section 07-10. 
(2)  Move the wing trestles into position.  Refer to Section 07-10. 
WARNING: MAKE SURE THAT THE ENGINE IS SAFE BEFORE YOU DO ANY WORK ON THE PROPELLER. IF THE ENGINE IS TURNED, THE PROPELLER CAN CAUSE INJURY OR DEATH. 
(3)  Set the fuel selector/shut-off valve to CLOSED. 
(4)  Make sure that the engine is safe: S Set the ignition switch to OFF. S Set the throttle to IDLE. S Set the mixture control to LEAN CUT-OFF. 
(5)  Remove the engine cowlings.  Refer to Section 71-10. 
(6)  Remove the airplane battery.  Refer to Section 24-31. 
(7)  Disconnect the spark plug cables from the spark plugs. 
(8)  Remove the spark plugs and put blanks in the spark plug holes in the cylinders.  This will stop contamination going into the engine cylinders. 

Doc # 6.02.01 Page 203
Rev. 4 09 Jan 2003

71-00-00 71-00-00
Power Plant  DA 40 Series 
AIRCRAFT  AMM 
Engine Mount to 
Firewall Bolt 
Propeller Control  Manifold Pressure Connector 

LYCOMING  LYCOMING 
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:钻石40飞机维护手册 DA 40 SERIES AMM 5(2)