• 热门标签

当前位置: 主页 > 航空资料 > 国外资料 >

时间:2010-08-11 13:26来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

RWY TURN OFF - Same as nose lights
A light on each wingtip and one on the tail cone.
AUTO - Strobes on when struts not compressed
AUTO - ON when all eng running and either slats or main gear is extended.
- Gives low tone chime
- On gnd, signs remain on after slats retracted
AUTO - (A330) Signs (NO SMOKING & EXIT) on when gear extended.Signs
off when gear retracted
AUTO - (A340) Signs (NO SMOKING & EXIT) on when gear extended or slats
are extended
Note: When cabin alt is excessive (14,350ft), cabin lights come on. NO
SMOKING, FASTEN SEAT BELT, EXIT signs come on regardless of their
switch pos’n.
EMER EXIT LT
ARM - Cabin emerg lighting illuminates if:
- DC ESS BUSS fails or
- normal a/c elec pwr fails
- The overhead emerg lights auto illuminate if AC
BUS 1 fails. This gives min cabin lighting
EMER EXIT LT-OFF Lt - Amber when EMER EXIT LT sel is selected OFF
Overhead Panel Switches
10-Aug-10 For reference only 26
OFF ATT
34.NAVIGATION
ADR 1 (2,3,4)
OFF - Air data output disconnected
FAULT Lt - Amber with ECAM if fault detected in the Air Data Ref.
NAV
OFF - ADIRU not energized
NAV - Normal
ATT - IR mode supplying attitude & heading.
- no nav capability
- hdg must be entered thru MCDU regularly ( approx 10
mins)
Complete realign - sel OFF for more than 5 secs. Takes approx. 10 min
- recommend before long range flight
Fast realign - cycle OFF then ON within 5 secs. Takes approx. 3 min
IR 1 (2,3)
OFF - inertial data output disconnected
FAULT LT - Amber with ECAM if fault detected.
- steady light = respective IR is lost
- flashing light = attitude & heading may be recovered in ATT mode
Light Only
Amber when 1 or more IRS supplied by batteries.
If Amber on ground - external horn sounds
- ADIRU Lt on SERVICE INTERPHONE BAY panel
comes on.
GPWS
Mode 1: Excessive RoD –“SINK RATE” & “PULL UP”
Mode 2: Excessive Terrain Closure – “TERRAIN” & “PULL UP”
Mode 3: Altitude Loss After T/O – “DON’T SINK”
Mode 4: Unsafe Terrain Clearance – “TOO LOW-GEAR (FLAPS,TERRAIN)”
Mode 5: Descent Below Glide Slope – “GLIDE SLOPE”
EGPWS: “TERRAIN AHEAD” & “PULL UP”
Overhead Panel Switches
10-Aug-10 For reference only 27
SYS
OFF - All GPWS alerts (1 to 5) inhibited
FAULT LT - Amber with ECAM when GPWS fault detected
Note: ILS 1 fails, only mode 5 inhibited. No Fault Lt or warning.
G/S MODE
OFF - Glide slope mode (mode 5) inhibited.
FLAP MODE
OFF - Flap mode (“TOO LOW-FLAPS) inhibited.
- Avoids warnings with landing at reduced flap.
- CONF 3 sel in MCDU auto inhibits warning when Flap 3 is reached
TERR
OFF - Inhibits Terrain Awareness Display (TAD) & Terrain Clearance Floor
(TCF) modes
- Does not affect basic GPWS modes 1 to 5.
FAULT Lt - Amber with ECAM if TAD or TCF made fails.
OTHER SYSTEMS
NWS TOWING
FAULT - Red on gnd when NWS has exceeded 93˚ (Red light also on nose
ldg gear)
Pressed - Light goes out
Overhead Panel Switches
10-Aug-10 For reference only 28
35. OXYGEN
CREW SUPPLY
High pressure cylinders in LH lower fuselage.
Over pressure auto supplied above 30,000ft cab alt to help prevent
condensation etc
Mix of cabin air and oxy up to 35,000ft cab alt. 100% oxy above 35,000ft cab alt.
ON - Valve is open, supplying low pressure oxy.
- is normal position in flight
OFF - Valve closed. White light on.
A340 - Pneumatic latching system allows masks to fall when cab alt exceeds 14,000ft (+0, -
500ft). Altimetric flow regulation device controls passenger flow rate from oxy cylinders located
behind RH sidewall lining in FWD cargo compartment.
A330 - Electric latching system allows masks to fall when cab alt exceeds 14,000ft (+0, -500ft).
Oxy delivered at constant pressure by oxygen generator which last about 22 min. Oxy generation
may emit heat and smoke.
PASSENGER SYS ON
White light when system on. Remains on until RESET on maint panel is pressed.
MASKS MAN ON
PA automatically broadcasts instruction whether MAN or AUTO
deployment
AUTO - Normally in AUTO position. Masks auto drop at 14,000ft cab
alt.
Pressed - Masks drop
RESET (A340)
Maintenance crew use this pb to reset after the system has operated.
ON - White light comes on, PASS SYS ON light goes off, PA recording stops.
- System shut off valves close
- Main supply line shut off valves open
- ON light goes off when reset complete (3 sec)
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:航空资料5(28)