2-3-1
ENGINE SPECIFICATIONS
Page 2-8 Apr 11/2002 D623N005
757
PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
2-3-1
ENGINE SPECIFICATIONS
Page 2-9 Apr 11/2002 D623N005
2.4 NACELLE COMPONENTS
2.4.1 Nacelle Description
The engine nacelle components are shown in Figure 2-7 and Figure 2-8 and their weights and CG are shown in Figure 2–10 Nacelle Component Weights and CG.
2-4-1
NACELLE COMPONENTS
Page 2-10 Apr 11/2002 D623N005
2.5 INLET COWL
2.5.1 Inlet Cowl Description
The inlet cowl consists of an aluminum lip skin, an outer Kevlar/graphite panel, and an acoustically treated inner panel. Fastened to the engine front cowl flange, the inlet cowl may remain attached during the removal of the engine from the strut.
2-5-1
INLET COWL
Page 2-11 Apr 11/2002 D623N005
2.6 FAN COWL
2.6.1 Fan Cowl Description
The fan cowl is composed of two curved Kevlar/graphite panels hinged at the top and attached to the strut. These panels can be lifted 558 from the closed position for access to the engine during maintenance. Telescoping hold-open rods are built-in between the cowl panels and the engine.
2-6-1
FAN COWL Page 2-12 Apr 11/2002
D623N005
2.7 THRUST REVERSER
2.7.1 Thrust Reverser Description
The thrust reverser is in two halves. Each half consists of a translating sleeve, fan duct, cascade flow control device and actuating system. Hinge pins and hinge fittings connect each half to the strut. Each half is opened hydraulically by a hand-operated pump for access to the engine during maintenance. Built-in hold-open rods should be used to support the open thrust reverser when working on the engine. Latches are located on the lower edges for locking the halves together.
The translating sleeve is the outer panel of the thrust reverser. It is moved aft in the reverse thrust configuration to expose the cascade area and actuate the blocker doors.
2-7-1
THRUST REVERSER
Page 2-13 Apr 11/2002 D623N005
2.8 CORE COWL
2.8.1 Core Cowl Description
Made of bonded aluminum, the core cowl consists of two curved panels. Hinge fittings are located on the top edge and attached to the strut. The two lower edges are held together by latch and keeper assemblies.
2-8-1
CORE COWL Page 2-14 Apr 11/2002
D623N005
2.9 EXHAUST SLEEVE
2.9.1 Exhaust Sleeve Description
This section consists of an exhaust nozzle and outer sleeve assembly. The whole assembly is connected to the
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 PW2000 Series Engine Ground Handling Document 发动机地面处理文件(9)
