3-6-1
NACELLE COMPONENT REMOVAL
Page 3-22 Apr 11/2002 D623N005
3.7 STRUT
3.7.1 Engine Strut Description
Each engine strut is the support structure between the engine and the airplane wing. Each contains the forward and aft engine mounts, engine precooler, air ducts, fuel lines, hydraulic lines and electrical lines. Figure 3-15 shows the basic strut and the method of installation to the wing.
ENGINE STRUT INSTALLATION/REMOVAL
The strut is installed and removed with an overhead sling (Figure 3-16) which attaches to two GSE hard points, at Nacelle Station 128.0 and 174.92, on both sides of the strut. The sling consists of an inboard and outboard frame connected by a lifting bar extending across the top of the strut. The lifting bar has provisions for overhead hoist attachment.
Strut installation requires overcoming a maximum 3000 lb (1361 kg) vertical preload. The preload is applied, either up or down, through a preload fixture (Figure 3-17) which attaches to the forward engine mount provisions. The preload is measured with a dynamometer mounted between the hoist and the preload fixture.
3-7-1
STRUT
Page 3-23 Apr 11/2002 D623N005
757
PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
3-7-1
STRUT
Page 3-24 Apr 11/2002 D623N005
757
PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
3-7-1
STRUT
Page 3-25 Apr 11/2002 D623N005
Side link installation determines the size of the gap between the strut and wing fittings. The alignment fixture (Figure 3-18) gauges the bushing location that is required to maintain the gap within limits.
The upper link, diagonal brace, and mid spar fuse pins can also be replaced with the engine on-wing with the use of the sling as shown in Figure 3-19. Note the alternate configuration required when removing / installing the mid spar fuse pins because of the necessity to apply a differential load to the engine and strut. The crane scale provides the visibility of the load exerted: maximum 13,500 lb (6123 kg).
3-7-1
STRUT
Page 3-26 Apr 11/2002 D623N005
757
PW2000 SERIES ENGINE GROUND HANDLING DOCUMENT
Figure 3-19 STRUT UNLOAD SLING WITH THE ENGINE INSTALLED
3-7-1
STRUT
Page 3-27 Apr 11/2002 D623N005
3.8 BOEING-DESIGNED GROUND SUPPORT EQUIPMENT
3.8.1 Boeing GSE Identification
Below is a list of ground support equipment for the PW2000 series engine.
TOOL NOMENCLATURE DRAWING IDENTIFICATION
INLET COWL SLING A71005
CORE COWL INSTALLATION/REMOVAL SLING A71016
OVERHEAD ENGINE SLING B71027
BOOTSTRAP HOIST B71022
EXHAUST SLEEVE INSTALLATION/REMOVAL CRADLE B71028
CORE COWL & THRUST REVERSER HOLD-OPEN TOOL B71020
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 PW2000 Series Engine Ground Handling Document 发动机地面处理文件(15)
