• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-09-28 12:39来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 632HZ Dry Bay Access Door (Right)
 641AB Main Tank Access Door (Right)
 641BB Main Tank Access Door (Right)
 641CB Main Tank Access Door (Right)


 D.
Procedure


 NOTE: You can apply faying surface sealant between the dry bay
____
 access door and the dry bay panel (optional).

 S 424-023
 (1)  
If you want to install a gasket between the dry bay access door and the dry bay panel, do these steps:

 (a)  
Apply a thin layer of BMS 5-26 sealant on the faying surface of the dry bay access door.


 NOTE: Sealant must be applied to all faying surfaces to
____ get a continuous sealant layer between the rubber gasket and the dry bay access door.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-11-07
 ALL  ú ú 01 Page 405 ú May 28/01

A

757 MAINTENANCE MANUAL
 (b) (c) (d)  Install the gasket on the dry bay access door.Use the dry bay access door as a template and make (punch, not drill) holes through the gasket.Make sure all the fastener holes on the gasket are not damaged.
 S 424-024
 (2)  Install the grounding bolts and washers (four locations) to connect the dry bay access door to the dry bay panel.
 S 424-025
 (3)  Install the bolts and washers with wet sealant to attach the dry bay access door to the wing structure as follows: (a) Install the bolts and washers in a star pattern. 1) Tighten the 3/16 inch diameter bolts to a torque of 15-20 pound-inches. 2) Tighten the 1/4 inch diameter bolts to a torque of 30-50 pound-inches. (b) After the initial installation, tighten the bolts again to the subsequent values: 1) Tighten the 3/16 inch diameter bolts to a torque of 30-35 pound-inches. 2) Tighten the 1/4 inch diameter bolts to a torque of 65-100 pound-inches.
 S 394-027
 (4)  Apply a fillet seal around the edge of the dry bay access door (AMM/51-31-01/201).
 S 224-014
 (5)  Make sure the bonding resistance between the dry bay access door and the wing structure is not more than 0.10 ohms (AMM 20-10-21/401).
 S 224-015
 (6)  Make sure the bonding resistance between the dry bay panel and the wing structure is not more than 0.01 ohms (AMM 20-10-21/401).
 S 414-014
 (7)  Install the applicable main tank access door in the subsequent table for the applicable dry bay access door (AMM 28-11-01/401).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:757 AMM 飞机维护手册 燃油 CHAPTER 28 - FUEL 2(10)