AMES MATERIAL SERVICES, INC.PROCEDURES MANUAL(9)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

Q.  CASE - Coordinating Agency for Supplier Evaluation.
R.  CATASTROPHIC - A term applicable to parts, appliances, characteristics, processes, maintenance procedures or inspections, which if failed, omitted, or nonconforming, may, considered separately and in relation to other systems, reduce safety margins, degrade performance, or cause loss of capability to conduct certain flight operations, so as to prevent the continued safe flight and landing of the aircraft such conditions may require use of the Emergency Procedures portion of the Flight Manual. The term “catastrophic” implies a requirement for extraordinary care in technical evaluation and control to assure safety of product, personnel, and the public.

S.  CERTIFIED TRUE COPY - An accurate duplication of a document. All Certified True Copies as identified in the manual will be stamped as such accompanied with the initials of the individual and the date it was created. The only individuals approved for initial authority are those on the Inspection Roster.
T.  CERTIFICATED MANUFACTURER - A manufacturer who holds a production approval under CFR 14, Part 21.
U.  CERTIFICATE OF CONFORMANCE - A document which certifies conformance to a manufacturer’s process, design, specification and materials, as well as test reports or supporting data.
V.  CERTIFICATION OF AIRWORTHINESS FOR EXPORT - A certificate used between countries, holding a bilateral agreement, to export aircraft parts. This certificate identifies the condition of an item (aircraft component/part), that it conforms to its type design, and that it is in a condition for safe operation. Examples of this are the JAA Form 1 and the FAA Form 8130-3.
W.  CERTIFICATION DOCUMENT - A document/certification stating that a part conforms to an industry or U.S. specification. NOTE: Manufacturers of commercial and standard parts are not all certificated by the FAA and therefore may not be subject to FAR requirements.
X.  CERTIFICATED PART - A part which is approved by the FAA and manufactured by a certificated person (e.g., Type Certificate holder, Supplemental Type Certificate Holder, production certificate holder, TSO holder or PMA holder). All of these certifications for manufacture are delineated in the FAR’s. All of them are subject to an established and approved quality control system, which assures that a part in all ways, meets its design data.
Y.  COMPONENT - Any self-contained part, combination of parts, subassemblies or units, which perform a distinctive function necessary to the operation of a system.
Z.  CONFORMITY TO FAA-APPROVED DESIGN DATA - An assessment of whether the material, part or product is consistent with the FAA-Approved design data.
AA.  CONSUMABLES - Generally bulk-type materials such as fuel, lubricants, cements, compounds, paints, chemicals, dyes, splices patches, etc., called out in maintenance and repair procedures for aircraft, engines, equipment, and component end items. These materials are items used only once.
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：AMES MATERIAL SERVICES, INC.PROCEDURES MANUAL(9)