(2)
All aircraft related materials, components, assemblies and sub-assemblies which have been dropped or subjected to a harsh blow, jarring and/or banging will be transferred to a repair facility.
(3)
All ESDS will be identified by an industry standard emblem. These emblems will be placed in plain sight on the outer packaging of the unit or component. Piece parts as well as components will have static shielding conductive bag or protective conductive caps.
(4)
In the event that static sensitive devices are found in any area (except during shop repair) without their respective protective bags or conductive caps, proper protective bags or caps should be installed and the device routed to Repair Services for a service evaluation by either AMES, Inc. Component Repair or an outside vendor.
3. Components Requiring Extreme Care or Caution
A. Radar Transceivers will not be placed in close proximity of gyroscopic units. The magnetic force of the transceiver may seriously damage the gyroscopic unit.
B. Avionics, gyroscopic and indicator/instrument components will be handled with extreme care to avoid damage.
NOTE: Lifting one end of a Rate Gyroscope . inch and dropping it on a bench may result in being sufficient enough to damage the Gyroscopic unit.
C. Sheet Metal will be handled to prevent distortion, scratches and perforations. These will all weaken the metal and may render the metal useless.
D. High pressure gas cylinders may contain oxygen, nitrogen or refrigerant at pressures up to 3500 psi, depending on charge and temperature. They should be handled with the utmost of caution and respect. Empty or unserviceable cylinders may contain dangerously high pressures, treat all high pressure cylinders as though fully charged.
NOTE: Compressed gas containers are safe for the purpose intended. Accidents involving cylinders are usually traceable to mishandling.
E. All ESDs devices must be labeled and shipped with ESD protection (conductive caps or static shielding conductive bags). ESD labels are not required on shipping containers.
F. All ESDs devices that have either a conductive cap over the exposed connector or conductive material are considered protected. Printed circuit boards or package in conductive bags are to be considered ESD protected.
4. ESDS Work Station
A. A check of the ESD mat and wrist strap will be performed using a Surface Resistivity Meter (SRM) with Resistance to Ground (RTG) capability.
CAUTION: DO NOT HANDLE ESDS DEVICES WITH ANY WRIST STRAP OR WORKSTATION MATS FAILING ANY OF THESE TEST UNTIL THE PROBLEM IS CLEARED.
CHAPTER: 10 SECTION: 01 PAGE:
3
A Wholly Owned Subsidiary of AMES, Inc.
NOTE: The following steps are instructions for using tester Model BSRM-6. Alternate ESD tester Model EN425-100 can be used in lieu of this model. 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址：AMES MATERIAL SERVICES, INC.PROCEDURES MANUAL(33)
