• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2011-04-23 09:57来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

2.15.4 Engine Fuel System Components. Control of fuel to the combustion system is done by the HMU. The HMU, mounted on the rear center of the accessory gear box (Figure 2-9), contains a high pressure pump that delivers fuel to the POU. Various parameters are sensed by the

OIL  FUEL FILTER IMPENDING  FUEL PRESSURE  INLET PARTICLE  Np 
COOLER  BYPASS BUTTON  SENSOR  SEPARATOR  (%RPM) 
BLOWER  SENSOR 

OIL LEVEL BLEED.AIR PORT ANTI.ICING AND MAIN FUEL IGNITER PLUG PRIMER FUEL INDICATOR START BLEED VALVE NOZZLE NOZZLE
LEFT SIDE 
ALTERNATOR  OIL FILTER  OIL FILTER 
BYPASS SENSOR  BYPASS BUTTON 
CHIP DETECTOR 
FUEL BOOST 
OIL TEMPERATURE  PUMP 
SENSOR 
FUEL FILTER 
SWIRL VANES 
OIL PRESSURE 
SENSOR 

OIL DRAIN PLUG
AA9916_1

FRONT VIEW
SA

Figure 2-9. Engine T700 (Sheet 1 of 2)
ACCESSORY SECTION MODULE

THERMOCOUPLE 
HARNESS  OIL FILLER 
HYDROMECHANICAL UNIT  CAP  HISTORY RECORDER 
IGNITOR  STARTER 
PLUG 
TORQUE AND 
OVERSPEED SENSOR 

HOT SECTION MODULE (INTERNAL)  ECU  IGNITION EXCITER  OIL LEVEL INDICATOR 
POWER TURBINE MODULE  COLD SECTION MODULE 
RIGHT SIDE  SA AA9916_2 
Figure 2-9. Engine T700 (Sheet 2 of 2) 

HMU and in.uence fuel .ow, variable geometry position, and engine anti-ice start bleed valve operation. Fuel from the HMU .ows to a POU.
2.15.4.1 Pressurizing and Overspeed Unit. The POU sends some of the fuel through the fuel start manifold tube to the primer nozzles and allows back .ow of high pressure air for purging. The rest of the fuel is sent through the main fuel manifold to the injectors for starting accelera-tion and engine operation. It purges fuel from the primer nozzles after light off. It purges fuel from the primer nozzle and main fuel manifold on shutdown. It also reduces fuel .ow to prevent an engine overspeed when the overspeed system is tripped as sensed by the ECU.
2.16 ENGINE ALTERNATOR.
2.16.1 Engine Alternator. The engine alternator (Fig-ure 2-9) supplies ac power to the ignition exciter and elec-trical control unit (ECU). It also supplies a signal to the Ng SPEED cockpit indicator. All essential engine electrical functions are powered by the alternator.
a. When the alternator power supply to the ECU is in-terrupted, a loss of % RPM 1 or 2 and % TRQ indications will occur, with corresponding engine(s) increasing to maximum power (high side).
Change 4 2-21

b.
When the alternator Ng signal is interrupted, a loss of Ng cockpit indication will occur with a corresponding ENG OUT warning light and audio.

c.
A complete loss of engine alternator power results in affected engine(s) increasing to maximum power (high side) with a loss of cockpit indications of % RPM 1 or 2, % TRQ, Ng SPEED; and ENG OUT warning light and audio will occur. Overspeed protection is still available.


2.17 IGNITION SYSTEM.
The engine ignition system is a noncontinuous ac pow-ered, capacitor discharge, low voltage system. It includes a dual exciter, two igniter plugs, ignition leads, and ENGINE IGNITION keylock switch.
2.18 HISTORY RECORDER.
The engine history recorder is mounted on the right side of the swirl frame (Figure 2-9). It displays four digital counters which records information for maintenance pur-poses only. The history recorder will only operate with an ECU.
2.19 THERMOCOUPLE HARNESS.
A seven probe harness measures the temperature of the gases at the power turbine inlet. It provides a signal to the ECU, that relays it to the history recorder through the sig-nal data converter (SDC) to the cockpit temperature gage.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:UH-60Q 直升机技术手册 直升机操作手册 1(19)