S1 MENU Displays the main menu.
S2 NEXT Selects other timing functions.
CONTROL/ LEGEND S3 RESET S4 STARTor STOP
S1 MENU S2 NEXT S3 RESET S4 START or
STOP
S1 MENU S2 NEXT S3 UP
S4 DOWN
3.20.3.4 Options Mode. Displays the latest built-in-test result and allows the pilots to initiate a complete self test (Figure 3-32, Options Menu). OK indicates no faults de-
tected during continuous self test. FAULT indicates a fault is detected (Table 3-3). The system will always power up with HDG Stabilization on. If the aircraft external heading
FUNCTION
Returns stopwatch digits to zeros.
Starts or stops stopwatch time counting feature. Elapsed Timer Mode
Displays the main menu.
Selects other timing functions.
Returns elapse time digits to zeros.
Starts or stops elapsed timer
counting feature.
Set Current Time/Date Mode
Displays the main menu. Highlights the digits to be changed.
Increments number(s). the highlighted
Decrement number(s). the highlighted
source (gyro) fails, the HDG Stabilization feature should be turned off manually. Also, HDG Stabilization should be manually disabled if a compass failure occurs without caus-ing a .ag condition. When operating in the HDG Stabiliza-tion mode, the pilots may elect to have the Heading Display on or off in any weather mode. When Heading Display is on, the aircraft heading will appear as a digital readout at the top of the display. The following controls and functions are available on the options menu:
CONTROL/ FUNCTION
LEGEND
CONTINUOUS Displays status ON or OFF of built
TEST in test.
HDG Stabilization: Displays status of heading
stabilization ON or OFF.
Heading Display: Displays status of heading display
ON or OFF.
S1 MENU Access the main menu.
S2 NEXT Steps the highlight bar through the
menu selections.
CONTROL/ FUNCTION
LEGEND
S4 TEST Initiates the built-in-test when
highlight bar is over Continuous
Test, and toggle between ON and
OFF for HDG Stabilization and
Heading Display selections.
3.20.3.5 Navigation Display Mode. Weather mapping screen will also display course line to selected waypoints, a course deviation indicator and up to 6 additional data items provided by AMS. On initial start-up, the navaid mode will attempt to display range, ground speed, estimated time en-route, bearing, crosstrack error and estimated time of ar-rival. These additional items may be modi.ed in the op-tions mode.
3.20.4 Storm Scope Normal Operation. After the storm scope is turned on, a self test is automatically per-formed by internal diagnostics to verify system readiness. This test takes approximately 15 seconds. SYSTEM TEST IN PROGRESS should be displayed while test is being performed. Upon satisfactory completion of all tests, ALL TESTS ARE OK will be displayed for 3 seconds, then will be replaced by the main menu. If system is turned on cold, the test may be completed prior CRT start. In this case, the initial display will be the main menu.
Table 3-3. Storm Scope Error Messages.
ERROR MESSAGE ACTION
Bus Error Video Error Data Error Program Memory Video Memory
Real-Time Clock Real-Time Clock Battery
Antenna
Analog Processing
Heading Processing
Microphone Key Stuck HARDWARE ERROR Continued operation is not possible
HARDWARE ERROR Time of day function not available
ANTENNA ERROR Storm information is not available
HARDWARE ERROR Storm information is not available
HARDWARE ERROR Heading stabilization and display not available
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：UH-60Q 直升机技术手册 直升机操作手册 1(112)
