06 - COMPLETION STANDARDS
.
Awareness of landing limitations.
.
Use of correct landing technique and execution of standard landing.
.
Employs correct technique for use of reverse thrust and manual braking or properly monitors autobrake deceleration.
.
Avoids significant deviation from runway centerline.
07 - COMMON ERRORS
.
Overcontrolling in pitch or roll.
.
Flaring too high.
.
Failure to flare or flaring too late.
.
Not selecting idle thrust for landing.
.
Delayed selection of reverse thrust.
.
Failure to monitor SD WHEEL page and/or AUTO/BRK panel during deceleration.
.
Maximum reverse thrust maintained below 70 kt or reverse stowed before taxi speed.
.
Differential braking used during roll out.
A319/A320/A321 FLIGHT CREW TRAINING MANUAL NORMAL OPERATION BRIEFINGS LANDING - LANDING AND STOPPING THE A/C - 1.02.22 Page 4
REV 21 MAY 98
A319/A320/A321 FLIGHT CREW TRAINING MANUAL NORMAL OPERATION BRIEFINGS GO AROUND 1.02.23 Page 1
REV 21 MAY 98
. To perform a safe go around in accordance with standard procedures.
02 - SCHEDULE
Briefing duration : 15 minutes
03 - EQUIPMENT
.
FMGS Freeplay Trainer
DOC references :
.
QRH 3.09 (Normal procedures)
.
FCOM 1.22.30 (Flight guidance)
.
FCOM 3.03.23 (SOP’s)
.
FCOM 4.03.20 (MCDU Page description)
.
FCOM 4.05.80 (FMGS procedures)
04 - INSTRUCTOR’S ACTIONS
Briefing of the following key points.
MAIN
.
Situational awareness.
.
Correct announcement / crew actions.
.
Pitch control.
.
Navigation.
SECONDARY
.
Engine out.
.
Reject landing.
.
Go around without FD.
A319/A320/A321 FLIGHT CREW TRAINING MANUAL NORMAL OPERATION BRIEFINGS GO AROUND 1.02.23 Page 2
REV 21 MAY 98
The go-around mode is engaged by setting the thrust levers to the TOGA gate, provided at least CONF 1 is selected. Monitor FMA annunciations for correct operation.
If going around from a visual approach (FDs off), set thrust levers to TOGA, rotate to 15 nose up, and maintain VAPP or above. The restoration of the FDs may not give accurate pitch information as the FDs return in basic modes (HDG V/S).
Lateral navigation will stay in GA TRACK mode until the heading selector knob is pulled or pushed to engage HDG or NAV mode. The go-around can be flown with two autopilots engaged, but when another lateral or vertical mode is selected, one autopilot drops out. Speed target will be green dot when GA ACCEL ALT is reached, as the design assumes another approach will be flown, following the go-around.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320/A321 FLIGHT CREW TRAINING MANUAL 机组训练手册(41)