S 412-040
(6)
Put the PSU back in position (Ref 25-23-01).
S 202-048
(7)
Close the door. Make sure the door latches correctly.
S 202-049
(8)
Make sure the two latching pawls are fully engaged with the strikers.
S 222-050
(9)
Make sure the distance between the actuating-push-handle and the latch housing is 0.24 |0.03 inch.
TASK 25-28-01-002-041
6. Open the Overhead Stowage Bin Door That Does Not Operate (Fig. 201)
________________________________________________________
A. Access
(1) Location Zones
200 Upper Half of Fuselage
B. Procedure
S 822-052
(1) Put a small diameter rod (less than 0.11 inch) in the manual release hole. Push the small diameter rod to release the latch.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-28-01
ALL ú ú 03 Page 207 ú Dec 20/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
OVERHEAD STOWAGE BIN - REMOVAL/INSTALLATION
___________________________________________
1. General_______
A. This procedure contains the following tasks.
(1)
Remove the overhead stowage bin.
(2)
Install the overhead stowage bin.
TASK 25-28-02-004-002
2. Remove the Overhead Stowage Bin (Fig. 401)_______________________________
A. References
(1)
AMM 21-61-08/401, Zone Temperature Sensor
(2)
AMM 25-22-01/401, Sculptured Ceiling Panel
(3)
AMM 25-22-02/401, Lowered Ceiling Panel
(4)
AMM 25-23-01/401, Passenger Service Units
(5)
AMM 33-21-10/201, Passenger Compartment Illumination
(6)
AMM 33-51-05/201, Aisle Lights
B. Access
(1) Location Zone
200 Upper Half of Fuselage
C. Procedure
S 024-100
(1)
Remove the sculptured ceiling panel (AMM 25-22-01/401).
S 024-101
(2)
Remove the lowered ceiling panel (AMM 25-22-02/401).
S 024-196
(3)
Remove the fluorescent light if it is installed (AMM 33-21-10/201) and disconnect the electrical connector.
S 024-102
(4)
Remove the PSU and spacer panels (AMM 25-23-01/401).
(5)
Remove the screws on the outboard side of the bullnose.
(6)
Remove the emergency aisle light (AMM 33-51-05/201).
S 024-104
(7)
Remove the zone temperature sensor if it is installed (AMM 21-61-08/401).
(8)
Remove the bullnose
S 024-199
(9)
Remove the alignment pins between the adjacent overhead stowage bins.
S 024-197
S 024-103
S 024-105
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-28-02
ALL ú ú 01 Page 401 ú Jan 20/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
B-B
Overhead Stowage Bin Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-28-02
ALL ú ú 01 Page 402 ú Jan 20/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757 MAINTENANCE MANUAL
S 024-200
(10)
Remove the bolts, washers, bushings, and nuts to disconnect the lower turnbuckles.
S 024-201
(11)
Remove the bolt, washer, and nut to disconnect the diagonal strut at the top, outboard edge of the overhead stowage bin.
S 024-202
(12)
Hold the overhead stowage bin and remove the bolts, washers, bushings, and nuts to disconnect the top turnbuckles.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 EQUIPMENT/FURNISHINGS 1(79)
