757 MAINTENANCE MANUAL
2) Rub the surface until the polish becomes black. 3) Rub the surface with a clean, dry wiper until the area looks bright and continuous. 4) Remove the remaining polish with detergent.
NOTE: Refer to the instructions given before for use of
____ detergents.
P. Procedure - Clean the Air Grille Panels
S 147-028
(1) Clean the air grille panels with a vacuum cleaner.
TASK 25-00-00-377-029
3. Painting
________
A. General
(1) The procedures are in groups as follows:
NOTE: Each group contains equivalent types of materials that you
____ clean with the same detergents and procedures. Use the materials on the applicable airplane.
(a)
Paint the Tedlar Surfaces
(b)
Paint the Polycarbonate (Lexan) Surfaces
(c)
Paint the Textured Finishes (Non-Tedlar).
(2)
You must fully mix the paint. A mechanical paint mixer is recommended. Do not shake the water-emulsion paint too much because air bubbles will result.
(3)
Add the thinner to the paint before you apply the paint. Do not mix thinners that came from different vendors.
(4)
The air must be clean, and without dirt and lint to prevent comtamination of the coated surfaces as the paint becomes dry.
(5)
The color of the dry paint must be the same as the old paint. You must not see a line.
(6)
The paint that you apply by brush, spray, or aerosol container must conform to high grade commercial standards.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-00-00
ALL ú ú 01 Page 715 ú May 28/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
B.
C.
D.
757
MAINTENANCE MANUAL
WARNING:_______ OBEY THE INSTRUCTIONS FROM INDUSTRIAL HYGIENE, FIRE, AND SAFETY
ORGANIZATIONS FOR THE FACILITIES, EQUIPMENT, VENTILATION, AND
PROCEDURES. THE MATERIALS YOU USE ARE POISONOUS AND FLAMMABLE.
IF THE CORRECT PROCEDURES ARE NOT USED, INJURY OR DAMAGE CAN
OCCUR. DO NOT GET THE PAINT MATERIAL IN YOUR MOUTH OR EYES, OR
ON YOUR SKIN. PUT ON A PROTECTIVE SPLASH GOGGLE AND GLOVES
WHEN YOU USE THESE MATERIALS. MAKE SURE THE AIR FLOWS FREELY
THROUGH THE WORK AREA. USE THE NECESSARY RESPIRATORY
PROTECTION. KEEP THE PAINT MATERIAL AWAY FROM SPARKS, FLAME,
AND HEAT. THE PAINT MATERIAL IS POISONOUS AND FLAMMABLE AND
CAN CAUSE INJURY OR DAMAGE.
(7) Obey this WARNING during all of this task.Consumable Materials
NOTE: Use one of these:
____
(1)
C00040 Polyurethane Paint - BMS 10-83 Type II
(2)
C00039 Primer - BMS 10-83 Type I
(3)
C00036 Hi-Speed Lacquer - M49XY
(4)
G02021 Glazing putty, dual purpose No. 4
(5)
B00148 Solvent - Methyl Ethyl Ketone (MEK), TT-M-261
(6)
B00193 Solvent - BMS 3-2 Type 2
(7)
G00147 Masking Tape - No. 718
(8)
Detergent
(a)
B00156 High Concentrate 40-1
(b)
B00157 Spraywhite E
(c)
B00158 Clean Quick
(d)
B00161 Orvus WA Paste
(e)
B00294 Do-All Formula 1D or 3BAccess
(1)
Location Zones 200 Upper Half of the Fuselage
Procedure - Paint the Tedlar Surfaces
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
25-00-00
ALL ú ú 01 Page 716 ú May 28/99
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 AMM 飞机维护手册 EQUIPMENT/FURNISHINGS 1(11)
