曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
intended.
For straight in approaches, the recommended flying reference is FPV, which should be selected
during the initial approach.
Approach procedures including a PI-CF leg (PROC-T indicated on the MCDU F-PLN) are not
eligible for the use of NAV and FINAL APP modes.
RNAV approach can be performed in NAV-FPA (or NAV-V/S) modes provided :
The approach procedure ‐ does not include a PI–CF leg (PROC T indicated on the MCDU
F–PLN)
The approach stored in the navigation database has been produced ‐ by approved suppliers
compliant with ED76/DO200A requirements, or has been validated and is approved by the
operator.
‐ Before starting the approach, the crew must check the lateral FM F-PLN against the published
approach chart using MCDU and ND.
‐ The final approach is laterally and vertically monitored, using the appropriate data : the distance
to the runway or to the MAP versus altitude is the primary means of vertical navigation, the
deviation on the PFD may be unreliable.
RNAV approach can be performed in FINAL APP mode provided:
‐ The approach stored in the navigation database has been produced by approved suppliers
compliant with ED76/DO200A requirements, and the vertical flight path has been validated
by the operator, or, the lateral and vertical flight path has been validated and approved by the
operator.
Note: RNP SAAAR approaches coded in the navigation database must be fully validated by
the operator.
A330/A340 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES - NON PRECISION APPROACH
A330/A340 FLEET PRO-NOR-SOP-19 P 3/24
FCOM 19 AUG 10
If no minimum OAT is published on the approach chart, the effect of low OAT on obstacle
clearance needs to be evaluated.
‐ The final approach (FAF to runway or MAP), as extracted from the navigation database and
inserted in the primary F-PLN including altitude constraints, is not revised by the crew.
‐ Before starting the approach, the crew must check the lateral and the vertical FM F-PLN against
the published approach chart, using the MCDU and ND.
‐ The approach trajectory is laterally and vertically intercepted, before the FAF, or equivalent
waypoint in the FM F-PLN, so that the aircraft is correctly established on the final approach
course before starting the descent.
‐ The final approach is laterally and vertically monitored, using the VDEV and appropriate raw
data (distance to the runway, altitude, FPV).
Note: For additional information on recommended flight crew procedures, and on navigation
database flight path validation, the FCOM Bulletin ”Use of managed guidance in
approach and NAV database validation” and the FMGS Pilot’s guide (Refer to 99 Duref
Cible FCOM and Refer to 99 Duref Cible FCOM).
For RNAV approach with GPS PRIMARY:
An instrument approach procedure, not requiring GPS PRIMARY, must be available at
destination or destination alternate (and at required takeoff alternate, and en route alternate).
Check RAIM availability, using the PREDICTIVE GPS MCDU page. Before starting the
approach, check that GPS PRIMARY is available on both MCDUs.
If the GPS PRIMARY LOST indication appears on the ND during the approach, discontinue
the approach, unless:
GPS is not required ‐ and navigation accuracy is confirmed against the radio NAVAID raw
data, or
‐ For RNAV approach not requiring GPS, HIGH accuracy appears on the MCDU with the
appropriate RNP value.
‐ If GPS PRIMARY is lost on only one FMGC, the approach can be continued, using the
AP/FD associated to the other FMGC.
If the FM/GPS POS DISAGREE ECAM caution is triggered during the approach, discontinue
the approach.
If the FMS1/FMS2 POS DIFF message is triggered during the approach, discontinue the
approach, unless radio navaid raw data is available and indicates correct navigation to
continue the approach by using the AP/FD associated to the non-affected FMGC side.
A330/A340 FLIGHT CREW
OPERATING MANUAL
PROCEDURES
NORMAL PROCEDURES
STANDARD OPERATING PROCEDURES - NON PRECISION APPROACH
A330/A340 FLEET PRO-NOR-SOP-19 P 4/24
FCOM 19 AUG 10
For RNAV approach without GPS PRIMARY:
Before starting the approach, check FM position accuracy with radio NAVAID raw data.
Check, in addition, that HIGH accuracy is displayed on the MCDU with the specified RNP
value.
If HIGH accuracy is lost on one FMGC, the approach can be continued with AP/FD associated
to the other FMGC.
If HIGH accuracy is lost on both FMGCs, discontinue the approach.
If the FMS1/FMS2 POS DIFF message is triggered during the approach, discontinue the
approach, unless radio NAVAID raw data is available and indicates correct navigation to
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
A330/A340机组操作手册 FLIGHT CREW OPERATING MANUAL FCOM 9(147)
