曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
2.1 Position the housing end flush with the end of the housing channel.
2.2 Take the needle and supertack and tie an overhand knot approximately 1" from the end.
2.3 Pass the needle through the inside of the housing channel and then around the outside below
the housing end [Figure D]. The purpose is to choke the end of the channel so that the housing
does not protrude from the end.
7-118
2.4 Next take the needle and pass it through the top of the channel fabric over the housing [Figure E].
2.5 Take the needle and locate the grooves in the housing [Figure F]. Make three loops through
the channel, trapping the supertack in the grooves [Figure G].
2.6 Secure the running end with a surgeon’s knot and locking knot.
2.7 Twist the supertack together and trim with a 3/4" tail.
3.0 HARDWARE:
3.1 Take the needle and doubled supertack and pass it through the leg pad from the bottom next
to the edge of the leg snap [Figure H].
3.2 Pass the supertack over the bar of the snap and down through the pad [Figure J].
3.3 Continue with two more turns over the bar keeping the tackings next to each other [Figure
K].
3.4 Secure the two ends on the bottom
of the pad with a surgeon's knot
and locking knot [Figure L].
3.5 Twist the ends together and trim to
a 3/4" tail.
Parachute Repair Procedure
TITLE: 7.7.2 Cleaning and Washing Procedures
NUMBER OF PAGES: 2
APPLICABLE PRODUCTS: Most harness and container systems.
DESCRIPTION: Cleaning and washing parachute components.
AUTHORIZED REPAIRMEN: FAA Senior or Master Parachute Rigger
MATERIALS: Woolite® or similar mild liquid soap
LOTS of clean fresh water
MACHINES: Jumbo tumbler type commercial washing machine. It is not recommended to
do this in your home washing machine.
EQUIPMENT:
Medium stiffness scrub brush
Large pillowcase or laundry bag
Wash tub
Assortment of rags
Extra laundry
BACKGROUND
This procedure applies only to harness and container systems. Most canopy manufacturers do not
approve of washing their products to clean them. Doing so may alter the performance characteristics
of the canopy. Follow the instructions in the owner’s manual for each make and model of canopy.
COLORFASTNESS. It is important to check for colorfastness of certain types of materials. Colored
E thread and Ty-3 binding tape have shown a tendency for their colors to run when wet or damp. Red
is particularly prone to doing so. Before using the following procedures, the rigger or owner should
check for colorfastness. Do so by wetting a small area of the container including the binding tape
and then lay a damp piece of WHITE cotton t-shirt on the wet area. Leave for 30 minutes. Check to
see if any color has transferred to the cotton fabric. If not, then it is PROBABLY OK to wash the rig.
Remember, this procedure in no way guarantees that the colors will NOT run.
PROCEDURE
1.0 DISASSEMBLY:
1.1 Remove all canopies, AADs, and component parts such as toggles, RSL, ripcords, bags, and
elastic keepers as well as the packing data card.
2.0 HANDWASHING:
2.1 Soak the rig in lukewarm water. Apply straight Woolite® or soap onto the dirtiest areas and
scrub with the brush. Soak in lukewarm water for 20 minutes.
2.2 Scrub the rig vigorously all over. Soak for another 20 minutes.
2.3 Repeat step 2.2. For particularly dirty rigs, empty the first batch of soapy water and wash in
a fresh batch of soapy water.
2.4 Squeeze out as much soapy water as possible. Immerse in fresh, clean, cool water and rinse
several times until no further soap comes out.
7-119
7-120
2.5 Hang to dry out of direct sunlight. The use of a fan directly onto the rig will greatly speed up
the drying process.
3.0 MACHINEWASHING:
Wrap the hardware of the rig with the rags to pad them so they don’t beat the inside of the
machine.
3.1 Soak the rig in lukewarm water and apply Woolite® or other soap directly onto the dirtiest
parts. Scrub these parts vigorously. Allow these parts to absorb the Woolite® during the time
traveling to the laundromat.
3.2 Place the rig into the pillowcase or laundry bag and add extra padding such as some of your
extra laundry. Levi's® work exceptionally well for this. Tie off the pillowcase or bag to hold
everything in. Place in the washing machine, add more washing and Woolite® and wash in
warm water.
3.3 Run through at least two rinse cycles or hand rinse several times until no soap comes out.
3.4 Hang to dry out of direct sunlight. The use of a fan onto the rig will greatly speed up the drying
process.
4.0 SCOTCHGARD:
The use of Scotchgard® brand fabric protector has become commonplace in recent years.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
Parachute Rigger Handbook(101)
