• 热门标签

当前位置: 主页 > 航空资料 > 机务资料 >

时间:2011-10-29 12:39来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

 (a)  
11J2, EICAS CMPTR L

 (b)  
11J33, WARN ELEX A

 

 (24)
 Set the parking brake to the OFF position.

 S 865-702

 (25)
 Hold the CONFIG switch on the TEST panel in the T/O position.

 (a)  Make sure the red EICAS message, PARKING BRAKE, does not show on the top display when the EICAS COMPUTER switch is in the L and R positions.

 (26)
 Release the CONFIG switch.


 S 865-701
 S 865-703
  ú

 31-51-00
 ALL  ú ú 05 Page 527 ú Sep 28/00

A
757
MAINTENANCE MANUAL

 S 865-704
 WARNING:_______ KEEP PERSONS AND EQUIPMENT AWAY FROM ALL CONTROL SURFACES
 WHEN POWER IS SUPPLIED.  AILERONS, ELEVATORS, RUDDER, FLAPS,
 SLATS, SPOILERS, AND STABILIZER ARE FULLY POWERED SURFACES.
 INJURY OR DAMAGE CAN OCCUR WHEN POWER IS SUPPLIED.

 CAUTION: DO NOT OPERATE ALTERNATE DRIVE MOTOR FOR LONGER THAN FOUR
_______ MINUTES. PERMIT AT LEAST 20 MINUTES BETWEEN OPERATION SO THAT THE MOTOR CAN BECOME COOL. DAMAGE CAN OCCUR IF THE MOTOR BECOMES TOO HOT.
 (27) Open these P11 panel circuit breakers:
 (a)  
11G12, FLAP/SLAT ELEC UNIT 1 POWER

 (b)  
11G13, FLAP/SLAT ELEC UNIT 1 CONT

 (c)  
11G14, FLAP/SLAT ELEC UNIT 1 SENSOR


 S 865-826
 (28)
 Put the LE and TE switches in the NORM position.

 S 865-705

 (29)
 Set the FLAP control to the UP position.

 S 865-706

 (30)
 Hold the CONFIG switch on the TEST panel in the T/O position.


 NOTE: During the takeoff configuration warning test, messages
____ will show on the EICAS display. The messages will show for only 5 to 15 seconds after the CONFIG switch is released. To make sure of the message status, the CONFIG switch should be put in the T/O position.
 (a)  
Make sure the red CONFIG light comes on.

 (b)  
Make sure the WARNING lights come on.

 (c)  
Make sure the siren aural warning comes on.

 (d)  
Make sure the red EICAS message, FLAPS, shows on the top display.


 S 865-707
 (31)
 Release the CONFIG switch.

 S 865-708

 (32)
 Set the FLAP control to the 20-unit position.

 S 865-709

 (33)
 Hold the CONFIG switch on the TEST panel in the T/O position.


 (a)  Make sure the red EICAS message, FLAPS, does not show on the top display when the EICAS COMPUTER switch is in the L and R positions.
  ú

 31-51-00
 ALL  ú ú 03 Page 528 ú Sep 20/98
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:757 AMM 飞机维护手册 仪表 CHAPTER 31 - INSTRUMENTS 2(118)