MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(74)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

D. These maintenance procedures do not affect the certification basis of the seat unit, assuming qualified replacement parts are used. However, failure to replace damaged or defective components could affect the airworthiness of the seat.
E.  The installation and use of non-B/E Aerospace products/components on this seat assembly will affect the certification and warranty of the seat.
Page 14001
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

2. Checks
A. Daily Checks
Limited access time during Daily Checks, unless specifically indicated, does not normally allow enough time for component replacement. Consider the extent of the damage/defect to determine if the component replacement can be deferred until an appropriately scheduled maintenance period, or if the seat should be repaired immediately. (Refer to Table 14002.)
Table 14002 Daily Check Tasks
TASK  TIME REQUIRED 
1  Carry out a visual examination of the general condition of seat and seat covers. 
2  Check seat track fittings for secure attachment to floor tracks. 
3  Check the condition of all life vest pouches or flotation cushions. 
4  Check to make sure that recline controls operate correctly. 
5  Check all in-arm foodtrays for damage and correct operation. 
6  Check IFE and electrical components for proper operation. 
7  Check center console for serviceability of sliding tray assembly and proper functioning of PC power ports, if present. 

Page 14002
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES

B. Monthly Check - In Aircraft
Limited access time during Monthly Checks, unless specifically indicated, does not normally allow enough time for component replacement. Consider the extent of the damage/defect to determine if replacement/repair can be deferred until an appropriately scheduled Light Check or Heavy Check, or if the seat should be repaired immediately. (Refer to Table 14003.)
Table 14003
Monthly Check Tasks

TASK  TIME REQUIRED 
1  Carry out a visual examination of the complete seat assembly (Refer to IPL Figure 1). Examine parts for cuts, nicks, cracks, corrosion, scoring, damaged threads, excessive wear, and any defects that may impair the efficient operation of the seat. 
2  Seat Covers and Cushions (Refer to IPL Figure 1) 
Replace any cushion covers and seat back covers that have been damaged or are dirty/stained. These can be repaired/cleaned as required. Refer to CLEANING (Page Block 4000). 
Replace hook-and-pile fasteners on seat covers as required. 
3  Seat Assembly (Refer to IPL Figures 1, 3, 16, and 17) 
Check all seat belt shackles for damage and secure attachment. Repair/replace as necessary. 
Check all seat belts for damage and secure attachment. Repair/replace as necessary. 
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(74)