(d)
Remove jam nut (9) and washer (8) from threaded end of recline lock (5). Retain for reuse.
(e)
Remove recline lock (5) from bracket (11) mounted to side of the spreader (12).
(f)
Remove washer (7) and jam nut (6) from recline lock (5). Retain for reuse.
(2)
To install back recline lock (Refer Figure 6004)
(a)
Install jam nut (6) and washer (7) to recline lock (5).
(b)
Install recline lock (5) into bracket (11) mounted on the side of the spreader (12).
(c)
Install washer (8) and jam nut (9) as shown.
(d)
Install recline lock (5) to recline arm (2) with screw (1), washer (3), and nut (4).
(e)
Install clip-on actuator (10) on the threaded end of the recline lock (5).
(f)
Test operation.
(3)
To adjust back recline (Refer Figure 6004)
(a)
Loosen jam nuts (6, 9) used to secure recline lock (5) to bracket (11).
(b)
Position the seat back to desired recline angle.
(c)
Tighten jam nuts (6, 9).
(d)
Test operation.
Page 6008
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
E. Remove and Install Seat Control Cable Assemblies
1
5
7 3 2 6 4
Figure 6005 - Control Cable Assembly Procedures Table 6006 Control Cable Assembly Components ITEM
DESCRIPTION ITEM
DESCRIPTION
1
Control lever 5
Screw
2
Seat control Bezel 6
Extension spring
3
Cable lever 7
Washer
4
Cable assembly
NOTE: For specific part information, see IPL Figure 18.
Page 6009
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL MILLENNIUM. 88813 SERIES
(1)
Remove control cable assembly (Refer to Figure 6005) NOTE: Retain all parts removed during this procedure for reuse.
(a)
Identify and tag all the control cables to be removed.
(b)
Relieve tension on the cable assembly (4) by returning component to the normal position.
(c)
Remove the actuator from the recline lock.
(d)
Remove the screw (5) from the lever cable (3).
(e)
Remove the control lever (1).
(f)
Carefully remove the extension spring (6) from either end.
(g)
Remove the cable assembly (4) from the cable lever (3).
(2)
Install control cable assembly (Refer to Figure 6005)
CAUTION: MAKE SURE THAT YOU ATTACH CONTROL CABLE(S) IN THE CORRECT POSITION. CONTROL CABLES HAVE SPECIFIC LENGTHS, DEPENDING ON FUNCTION. INCORRECT INSTALLATION WILL PREVENT PROPER OPERATION AND MAY CAUSE DAMAGE TO SEAT MECHANISMS.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(34)
