(b)
Route the cable properly through the seat and endbay and secure with original cable clamp(s) or new cable tie(s).
(c)
Install the cable assembly (4) to the lever cable (3).
(d)
Attach the extension spring (6).
(e)
Install the control lever (1) through the seat control bezel (2).
(f)
Install the lever cable (3) and the screw (5).
(g)
Install the actuator to the recline lock.
(h)
Adjust tension and test for proper operation.
Page 6010
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
F. Remove and Install Seat Recline Control Cable
Figure 6006 - Recline Control Cable Procedures
(1)
Remove recline control cable (Refer to Figure 6006).
(a)
Partially disassemble the endbay assembly to expose the recline control button. Refer to DISASSEMBLY (Page Block 3000).
(b)
Relieve tension on the control cable by returning the back assembly to the normal position.
(c)
Press the spring clip on the bottom end of the recline control and extract from the armrest.
(d)
Cut the lock strap securing the recline control cable to the frame assembly.
(e)
Loosen the allen screw or pull the clip attaching the activator end of the recline control to the recline lock.
(f)
Remove the recline control cable.
(2)
Follow these directions to install recline control cable (Refer to Figure 6006)
CAUTION: ATTACH THE CONTROL CABLE(S) IN THE CORRECT POSITION. CONTROL CABLES HAVE SPECIFIC LENGTHS, DEPENDING ON FUNCTION. INCORRECT INSTALLATION WILL PREVENT PROPER OPERATION AND MAY CAUSE DAMAGE TO SEAT MECHANISMS.
(a) Make sure that the back assembly is in the normal position.
Page 6011
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
(b) Route the new recline assembly through the endbay and along the frame assembly and secure to the frame with lock straps.
(c) Press the actuator end of the recline control onto the rod on the recline lock and press the clip or tighten the allen screw to secure in position.
(d) Assemble the recline control button through the endbay assembly and install the spring clip.
(e) Rebuild the endbay to a serviceable condition.
Page 6012
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
ASSEMBLY
1. General
Assembly procedures can vary slightly for different Millennium. seat models.
A. Before assembly, inspect all parts for wear and/or damage that could cause failure of the seat assembly or any of its component assemblies. Always replace attaching parts (cotter pins, screws, washers, nuts, grommets, cable holders, etc.) with new parts. Replacing these low-cost items will help decrease maintenance that is necessary when these items fail.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(35)
