(3)
Prepare fabric for dry cleaning as follows:
(a)
Cover hook tape with pile tape to avoid fabric damage during dry cleaning.
(b)
Turn covers inside out.
(4)
Dip-wash/filter-rinse dry cleaning procedures are given in Table 4004.
Page 4007
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
Table 4004
Dry Cleaning Procedures
STAGE PROCEDURE
Dip wash a. Wet the fabric with solvent containing 3-5 grams per liter of detergent. b. Add water mixed with detergent (see the detergent or manufacturer’s recommendation) to the cage with a hopper or automatic metering pump. c. Circulate solvent without filtering for 7-10 minutes. d. Pump out the solvent and centrifuge the fabric.
Filter rinse a. Add distilled solvent and circulate continuously from the cage to the button trap to the pump to the filter to the cage for 3-5 minutes. b. Centrifuge for 2 minutes and then dry.
(5) Drying temperature:
Tumble dry flame-retardant wool and wool-blend fabrics with a maximum outlet air temperature of 120° F.
Page 4008
B/E AEROSPACE
COMPONENT MAINTENANCE MANUAL
MILLENNIUM. 88813 SERIES
INSPECTION/CHECK
1. Visual Inspection of Parts
A. Inspect all new or existing parts before installing them on the seat. Use a strong light and a 5x to 7x magnifying glass. When inspecting for damage or corrosion, an inspection mirror must be used to determine the condition of all exposed surfaces.
B. Refer to the manufacturer's instructions for detailed inspection, test, and overhaul procedures for recline locks and controls. The manufacturer of these parts is P.L. Porter Company, 6355 De Soto Avenue, Woodland Hills, CA 91367 (V1YSK1).
2. Seat Assembly Serviceability Inspection
Perform the following checks after any significant repair work or disassembly of the seat assembly. Replace any part that fails to meet the requirements of the check with a serviceable part. If a defective part is repairable, note the defect and assign that part for repair.
Table 5001
Detailed Inspection
DETAILED INSPECTION (ACCEPT/REJECT EACH ITEM LISTED)
Check for required tags on the seat assembly. If modifications have been made to the seat per service documentation, check that proper tags and/or entries have been applied.
Check that all parts are clean and free of cracks, corrosion, deterioration, and obvious signs of damage.
Check back assemblies and installations:
Check for proper seat back recline function.
Check for proper installation and function of the QuikLOC. device breakover lockout.
Check for missing parts, broken parts, and parts not securely attached or fastened.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：MILLENNIUM™ 88813 SERIES PASSENGER SEATS 旅客座椅(29)
