曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
The plastic trim, instrument panel and control knobs need only be wiped off with a damp cloth. Oil and grease on the control wheel and control knobs can be removed with a cloth moistened with solvent. Volatile solvents, such as those mentioned in paragraphs on care of the windshield, must never be used since they soften and craze plastic.
E. Harnesses and safety belts Harnesses and safety belts - refer to 25-13-00.
AAAA
Validity : S / N 1 - 9999 12-20-03Page 204
(BA) JUN 02
LUBRICATION
DESCRIPTION AND OPERATION
1. GENERAL
This section is provided to assist the operator and recommend the lubrication operations necessary for the aircraft maintenance.
Before performing the various lubrication tasks in each area, it is important to obey proper safety directives and to prepare access to the specific areas.
Use only clean and approved lubricants. Remove excess oil and grease that tend to accumulate near the fittings and lubrication areas.
Aircraft lubrication includes different lubrication areas :
- area 100 lubrication - refer to 12-21-01,
- area 200 lubrication - refer to 12-21-02,
- area 300 lubrication - refer to 12-21-03,
- areas 500 / 600 lubrication - refer to 12-21-04,
- area 700 lubrication - refer to 12-21-05.
2. LUBRICATION SERVICE NOTES
NOTE : Before lubrication, clean and wash, as necessary, the areas to be lubricated.
A. Lubricant application
1) Cleanliness is essential for good lubrication. Lubricants and dispensing equipment must be kept clean. Use only one lubricant in a grease gun or an oil can.
2) Store lubricants in a protected area. Containers should be closed at all times when not in use.
3) Wipe grease fittings and areas to be lubricated with clean lintfree cloths before lubrication.
4) Movable parts should be moved when possible in order to insure a complete lubrication.
5) When lubricating bearings which are vented, apply the lubricant sparingly and wipe off any excess.
6) After any lubrication, remove excess lubricant from all parts except the working ones.
B. Special instructions
1) After lubricating the pulleys, rotate them so that the cable bears on a new surface.
AAAA
Validity : S / N 1 - 9999 12 21-00Page 1
(BA) JUN 02
3. LUBRICANT APPLICATION METHOD
14122100AAAAMA4100 l 4
Pompe a graisse Burette Aerosol Pinceau Main
Grease gun Oil can Spray Brush Hand
It is recommended that the aircraft be parked in an area free from contamination due to sand, dust or other environmental conditions that may contribute to improper lubrication practices.
AAAA
Validity : S / N 1 - 9999 12 21-00Page 2
(BA) JUN 02
AREA 100 LUBRICATION
MAINTENANCE PRACTICES
1. AREA 100 LUBRICATION
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：TB20 MAINTENANCE MANUAL 12 SERVICING TB20飞机维护手册 12 保养(57)
