737-600/700/800/900培训手册 TRAINING MANUAL 2(23)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

and CDS calculates flap maneuver speeds
-VREF - shows the landing reference speed
-Triangle symbol - shows an airspeed bug the pilot
can set as necessary
-SET - the FMCS and the inner control can not move
the airspeed bugs.
The inner control sets the airspeed value.
Fuel Flow Switch
The fuel flow switch is a three position toggle type switch spring-loaded to the center position.
The RESET position does a reset of the fuel used displays to zero. It is enabled in the air and on the ground.
The RATE position shows the current fuel flow for each engine.
The USED position shows the fuel used for each engine since the last reset.
The fuel used display stays in view for ten seconds after you release the switch. At that time the display changes to fuel flow. If you hold the switch in the fuel used position for more than thirty seconds, CDS
31-62-00

 

737-600/700/800/900 TRAINING MANUAL CDS -- EFIS - ENGINE DISPLAY CONTROL PANEL finds this as a stuck switch, and the display changes
back to fuel flow.
Multi-function Display Switches
These are the multi-function switches:
-ENG (engine)
-SYS (system).

You can use the ENG switch to select on and off the secondary engine display on the lower display unit (DU).
You can use the SYS switch select on and off the system page on the lower DU.
31-62-00

737-600/700/800/900 TRAINING MANUAL

 

31-62-00-208 Rev 1 10/08/96
CDS - EFIS - ENGINE DISPLAY CONTROL PANEL
31-62-00

- 359 -

737-600/700/800/900 TRAINING MANUAL

CDS -- PRIMARY FLIGHT DISPLAY OVERVIEW General
The primary flight display (PFD) shows these indications:
-Airspeed
-Attitude
-Altitude
-Heading
-Vertical speed
-Autoflight mode annunciations
-Flight director commands
-Landing indications
-Radio altitude
-Time critical annunciations.

31-62-00

737-600/700/800/900 TRAINING MANUAL

31-62-00-300.002 Rev 1 03/07/2000

CDS - PRIMARY FLIGHT DISPLAY OVERVIEW
31-62-00
ALTEON PROPRIETARY - Copyright (c) - See title page for details

CDS -- PFD - AIRSPEED INDICATIONS Airspeed Indication
The airspeed indication on the primary flight display (PFD) shows computed airspeed and other airspeed related information from other airplane systems.
Speed Tape and Current Airspeed
The speed tape shows the computed airspeed from the air data reference section of the ADIRU on a moving scale. The total displayable range is 121 knots with indices every ten knots and numerical readouts every 20 knots.
Current airspeed shows as a digital readout in the center of the speed tape. The lowest value the digital readout can show is 45 knots.
If the current airspeed is equal to or less than the minimum operating speed as derived from the stall management yaw dampers (SMYD) then the highlight box around the digital readout will be amber. It will flash for ten seconds and then stay on steady until the underspeed condition no longer exists.
Airspeed Disagree Message
If the left and right airspeed indications disagree by 5 knots or more, the IAS DISAGREE message shows at the bottom of the speed tape on both the captain's and first officer's displays. The messages are amber.
737-600/700/800/900 TRAINING MANUAL

Mach Number
Mach number shows as a digital readout below the airspeed tape when the Mach number is more than 0.4. The display does not show when the Mach number is below
0.38 or if the Mach number display fails. Mach number is displayed in white.
Speed Trend Vector
The speed trend vector shows the value of the predicted airspeed in 10 seconds based on airplane current airspeed and inertial flight path acceleration. This vector shows when the speed trend is more than 4.5 knots. The trend vector is displayed in green.
Selected Speed/Selected Mach Number
There is a selected speed bug and a digital readout. The value of the selected speed or Mach number is the value the pilot selects on the DFCS mode control panel (MCP) or the value the FMCS calculates. The bug points to the selected speed on the speed tape. The digital readout above the speed tape shows the selected speed or the selected Mach number. The selected speed bug and readout are displayed in magenta.
When the selected speed or Mach number is off the scale, only half of the bug shows at the top or the bottom of the speed tape.

- 362 -
31-62-00

 

CDS -- PFD - AIRSPEED INDICATIONS Takeoff Reference Speeds
The speed tape shows these reference speed bugs for takeoff:
-Reminder for airspeed callout at 80 knots
-V1 (takeoff decision speed)
-VR (takeoff rotation speed)
-V2 (single engine climb speed)
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-600/700/800/900培训手册 TRAINING MANUAL 2(23)