FMC discrete word 2 has this data:
-Display IRS position difference.
31-62-00
737-600/700/800/900 TRAINING MANUAL CDS -- NAVIGATION INTERFACES - 3 The DEUs use this data to make the MAP and PLAN
displays on the navigation displays (ND).
FMC Transfer Relays
The relays do not operate in this installation so that the FMC supplies the data to the DEUs.
31-62-00
737-600/700/800/900 TRAINING MANUAL
31-62-00-108 Rev 1 07/05/2001
DEU 2
CDS - NAVIGATION INTERFACES - 3
31-62-00
737-600/700/800/900 TRAINING MANUAL CDS -- NAVIGATION INTERFACES - 4 THIS PAGE INTENTIONALLY LEFT BLANK
31-62-00
CDS -- NAVIGATION INTERFACES - 4 Multi-Mode Receiver
The ILS receivers in the multi-mode receivers (MMRs) send this data to both DEUs on ARINC 429 buses:
-ILS frequency
-Station identifier
-Localizer deviation
-Glideslope deviation.
The ILS inputs go to both input output controllers (IOCs) in each DEU to meet integrity requirements. A comparison is done between these two ILS inputs in each DEU.
VHF Omnidirectional Ranging (VOR) Receiver
The VOR receivers send this data to both DEUs on ARINC 429 buses:
-VOR frequency
-Station identifier
-Bearing data
-Marker beacon discrete bits
-Fault status.
NOTE: Marker beacon data is only sent from VOR/MB receiver 1.
Distance Measuring Equipment Interrogator
The DME interrogators send this data to both DEUs on ARINC 429 buses:
737-600/700/800/900 TRAINING MANUAL
-DME frequency
-Station identifier
-Slant range distance.
Navigation Control Panel
The navigation control panels send a ground discrete to the DEUs to show that an ILS frequency was tuned on the navigation control panel.
If a VOR frequency is tuned on the navigation control panel and the approach mode is selected on the EFIS control panel, the message, EFIS MODE/NAV FREQ DISAGREE shows on the navigation display. The same message also shows if an ILS frequency is tuned on the navigation control panel and the VOR mode is selected on the EFIS control panel.
Instrument Switching Module
The instrument switching module has a three-position switch for the VHF NAV function. The switch positions are:
-BOTH ON 1
-NORMAL
-BOTH ON 2.
The instrument switching module sends ground discretes to the DEUs to show data selection for the captain and F/O displays.
31-62-00
737-600/700/800/900 TRAINING MANUAL
CDS -- NAVIGATION INTERFACES - 4
In the NORMAL position, the captain displays show data from MMR 1, VOR 1, and DME 1 systems and the F/O displays show data from MMR 2, VOR 2, and DME 2 systems.
When BOTH ON 1 or BOTH ON 2 is selected, the captain and the F/O displays show navigation data from the selected source.
31-62-00
737-600/700/800/900 TRAINING MANUAL
31-62-00-109 Rev 1 07/09/2001
ILS TUNED-L ILS TUNED-R
NAV SOURCE SEL-L NAV SOURCE SEL-R
DEU 1
ILS TUNED-L ILS TUNED-R
NAV SOURCE SEL-L NAV SOURCE SEL-R
DME 2 INST SWITCHING
DEU 2
MODULE
CDS - NAVIGATION INTERFACES - 4
31-62-00
CDS -- NAVIGATION INTERFACES - 5 Traffic Alert and Collision Avoidance System
The traffic alert and collision avoidance system (TCAS) computer sends data to and receives data from the display electronic units (DEUs). The TCAS computer sends this data on two ARINC 429 buses:
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-600/700/800/900培训手册 TRAINING MANUAL 2(11)
