• 热门标签

当前位置: 主页 > 航空资料 > 国外资料 > ICAO >

时间:2010-07-18 19:15来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

sometimes used.
Note 2.- Guidance on frangrgrbili@o f markem is gfwn in
the Aerodrome Design Manual. Part 6 (in prepmution).
5.52 Unpaved runway edge msrlars
5.4.7.1 A roadholding position sign shall be provided at 5.5.2.1 Recommendation.- M a r b should be proall
road enbmces to a runway. videti when the extent of nn unpad runway is not clearly
indicated by the appearance of i~ssu$ ace compared &h that
ofthe surrovnding ground.
5.4.7.2 The road-holding position sign shall be located
1.5 m from one edge of the road (left or right as appopriate h & n
to the local traffic regulations) at the holding position.
5.5.22 Recommendation.- Where rwrwqy lights are
provided. the markers should be incorpomted in the light
Characteridcs fmturar. Where there are no lights, markers offlat rectangular
or conical shape should be placed so ns to delimit the run-
5.4.7.3 A road-holding position sign shall consist of an clearlyinscription
in white on a red background.
5.4.7.4 The inscription on a road-holding position sign
shall be in the national language, be in conformity with the Characteristics
local traffic regulations and include the following:
5.5.23 Recommendation.- Theflat ratangular mankers
a) a requirement to stop; and should have o minimum size of I m by 3 m and should be placed
with their long dimension pamliel to the runway centre line. The
b) where appropriate: conical markers sbuld haw a height not exceeding 50 cm.
Chapter 5 Annex 14 -Aerodromes
5.5.3 Stopway edge markers Location
Application 5.5.5.2 Recommendation.- Taxiway edge markers
should be installed at least at the same locations as would the
5.5.3.1 Recommendation.- Stopway edge markers should taxiway edge lights had they been used.
be provided when the extent of a stopway is not clearly indicated
by its appearance compared with that of the surrounding ground.
Characteristics
Characteristics 5.5.5.3 A taxiway edge marker shall be retroreflective
blue.
5.5.3.2 The stopway edge markers shall be sufficiently
different from any runway edge markers used to ensure that 5.5.5.4 Recommendation.- The marked surface as
the two types of markers cannot be confused. viewed by the pilot should be a rectangle and should have a
minimum viewing area of 150 cm2.
Note.- Markers consisting of small vertical boar&
camouflaged on the reverse side, as viewedfiom the runway, 5.5.5.5 Taxiway edge markers shall be frangible. Their
have proved operationally acceptable. height shall be sufficiently low to preserve clearance for
propellers and for the engine pods of jet aircraft.
5.5.4 Edge markers for snow-covered runways
5.5.6 Taxiway centre line markers
Application
5.5.4.1 Recommendation.- Edge markers for snow- Application
covered runways should be used to indicate the usable limits
of a snow-covered runway when the limits are not otherwise 5.5.6.1 Recommendation.- Taxiway centre line markers
indicated. should be provided on a taxiway where the code number is 1 or
2 and taxiway centre line or edge lights or taxiway edge
Note.- Runway lights could be used to indicate the limits. markers are not provided.
Location
5.5.4.2 Recommendation.- Edge markers for snowcovered
runways should be placed along the sides of the
runway at intervals of not more than 100 m, and should be
located symmetrically about the runway centre line at such a
distancefiom the centre line that there is adequate clearance
for wing tips and power plants. Sufficient markers should be
placed across the threshold and end of the runway.
Characteristics
5.5.6.2 Recommendation.- Taxiway centre line markers
should be provided on a taxiway where the code number is 3 or
4 and taxiway centre line lights are not provided if there is a
need to improve the guidance provided by the taxiway centre
line marking.
Location
5.5.6.3 Recommendation.- Taxiway centre line markers
should be installed at least at the same location as would
taxiway centre line lights had they been used.
5.5.4.3 Recommendation.- Edge markers for snow- Note.- See 5.3.16.12 for the spacing of taxiway centre line
covered runways should consist of conspicuous objects such as lights.
evergreen trees about 1.5 m high, or light-weight markers.
5.5.6.4 Recommendation.- Taxiway centre line markers
5.5.5 Taxiway edge markers
should normally be located on the taxiway centre line marking
except that they may be offset by not more than 30 cm where it
is not practicable to locate them on the marking.
Application
5.5.5.1 Recommendation.- Taxiway edge markers should Characteristics
be provided on a taxiway where the code number is 1 or 2 and
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:新建文件夹\附件14-机场 Aerodromes an14_v1_4ed(79)