(2)
The thrust mode select panel (TMSP) allows crew selection of thrust limit modes, alternate thrust limit ratings, and assumed temperature.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
22-32-00
ALL ú ú 02 Page 1 ú Jan 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
TMC SERVO28V DCL BUS
TMC DC
POWER28V DCC
SUPPLY
STBY BUSAUTO FLT WARNLEFT/RIGHT
EICAS CMPTR115V AC PWR GOOD
THRUST 5V DC SENSEL BUS A MODEA/T
TMC AC SELECT
DISC P11
PANEL
A/T DISCGND TEST DATAWARN. FAULT DATASYS 1& BITE
THRUST
AIR/GND
LIMIT
RELAY
BLEED DISCRETES
C MCDPGND TEST REQUESTGND TEST CONTROL DATA
RIGHT
LEFT
ECS BLEED CONFIG
CARD
RIGHT LEFT A/T DISCONNECT SW'S
IRUTHRUST
GO AROUND SW'S
RIGHT
LEVER ASSYDATALEFT
BUS
AIR DATA CMPTR
INPUTS
RIGHT
LEFT
ENG EEC
RIGHT
LEFT
FMC
B
PROGRAM PINS
MUX
FLAP POSFSEU 1 A/T ARM
A CMDA/TSERVO CMD
A/T SERVOMOTORSERVO AMP
TACH FEEDBACK GENERATOR
AFCS
MODE
CONTROL
REVERSE THRUST SWMICROAUTOTHROTTLE
SW PACKB RIGHT
LEFTPWR LEVERANGLE
EFISSYMBOL GENLEFT
THRUST MANGEMENT COMPUTER CENTER
B RIGHT
Thrust Management System - General
Figure 1 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
22-32-00
ALL ú ú 03 Page 2 ú Jan 28/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
TABLE 1 INPUT PARAMETERS TABLE 2 OUTPUT PARAMETERS
TMS Digital Inputs and Outputs
Figure 1 (Sheet 2)
D02534
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
22-32-00
ALL ú ú 07 Page 3 ú Dec 20/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
757
MAINTENANCE MANUAL
F. Thrust Lever Switches
(1) Disengagement of the autothrottle occurs if: either of two autothrottle disconnect switches (one on each thrust lever) is pressed, the A/T ARM switch on the MCP is positioned to OFF, or either thrust lever is set in the reverse thrust position. Pressing either of two go-around switches on the thrust levers causes the TMS to adjust thrust for a go-around.
G. Sensors
(1) The Inertial Reference Units (IRUs) and Air Data Computers (ADCs) provide environmental and attitude data to the TMS. The EPR transmitters provide actual EPR via the EICAS computers, and the autothrottle Power Lever Angle (PLA) transducers provide power lever angle to the TMS. The ECS bleed configuration cards provide engine bleed discrete signals.
H. Outputs
(1) TMS outputs consist of:
(a)
TMC output to the servomotor generator which drives the thrust lever cables through no-back clutches.
(b)
Fault data output to the MCDP.
(c)
Display of the engaged autothrottle mode on the EADI.
(d)
Display of thrust limit modes and calculated thrust limits on the EICAS display unit.
(e)
Reference "bug" on EPR indicator (EICAS display unit) driven to calculated limit.
I. Annunciation
(1) Annunciation of the engaged autothrottle mode appears on the left side of the Electronic Attitude Director Indicator (EADI). Thrust limit modes are selected on the TMSP and displayed on the EICAS display unit. Upon autothrottle disengage, the A/T DISC light illuminates on center instrument panel P1-3.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:757 AMM 飞机维护手册 自动飞行 AUTOFLIGHT 2(112)