(150) of the housing is fully against the AGB pad.
(7) Lubricate the threads of the 3 studs with graphite grease (Material No. CP2101).
(8) Install washers (160) and nuts (170) and continuously install the magnetic seal assembly until the housing flange is fully against the AGB pad.
(9) TORQUE the nuts (170) to between 55 and 60 lbf.in (0.62 and 0.67 m.daN).
(10) Depending on the drive pad on which you have replaced the magnetic seal assembly, install one of these units:
- IDG (Ref. TASK 24-21-51-400-040)
- starter (Ref. TASK 80-11-10-400-002)
F 『 EEFF : ALL E Page 82972-63-00
E E May 01/05 ERE
ECES E Subtask 72-63-00-410-070
F 『
E C F M E
E E
E 56-5B E
E E
E. Close Access
(1) Make sure that the work area is clean and clear of tool(s) and other items.
(2) Close the fan cowl doors (Ref. TASK 71-13-00-410-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
Subtask 72-63-00-710-058
F. Do a leak check of the replacement seal (Ref. TASK 71-00-00-790-006). If there are leaks (Ref. TASK 71-00-00-790-002).
5. Close-up
________ Subtask 72-63-00-942-052
A. Remove the warning notice(s).
F 『 EEFF : ALL E Page 83072-63-00
E E May 01/05 E E ECES E