C. Expendable Parts
-------------------------------------------------------------------------------FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
10 O-ring
10 O-ring
10 O-ring
10 O-ring
10 O-ring
10 O-ring
10 O-ring
10 O-ring
10 O-ring
10 O-ring
15 O-ring
15 O-ring
15 O-ring
15 O-ring
F EEFF : ALL E E ECES 72-63-00 02 -04072-63-00 02A-04072-63-00 03 -03072-63-00 03A-03072-63-00 03A-030A72-63-00 05 -14072-63-00 05A-14072-63-00 06 -08072-63-00 06 -080A72-63-00 06A-08072-63-00 03 -03072-63-00 03A-03072-63-00 03A-030A72-63-00 06 -080
『
E 72-63-00Page 802
E May 01/05EE -------------------------------------------------------------------------------FIG.ITEM |DESIGNATION |IPC-CSN -------------------------------------------------------------------------------
F 『
E C F M E
E E
E 56-5B E
E E
15 O-ring
15 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
30 O-ring
D. Referenced Information
72-63-00 06 -080A72-63-00 06A-08072-63-00 02 -05072-63-00 02 -050A72-63-00 02A-05072-63-00 03 -04072-63-00 03A-04072-63-00 05 -15072-63-00 05A-15072-63-00 05A-150A72-63-00 06 -09072-63-00 06A-090
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-21-51-000-040 24-21-51-400-040 29-11-51-000-041 29-11-51-400-041 71-00-00-790-002 71-00-00-790-006 71-13-00-010-040 71-13-00-410-040 73-11-10-000-003 73-11-10-400-003 80-11-10-000-002 Removal of the Integrated Drive Generator -IDG 1(2),(4000XU)Installation of the Integrated Drive Generator -IDG 1(2),(4000XU)Removal of the Green Engine Pump (1030GK)Installation of the Green Engine Pump (1030GK)Fuel or Hydraulic or Oil Leakage LimitsLeak Check after the Replacement of a Sealol Seal or a Magnetic Seal on the AGB Drive Pads of the IDG, Hydraulic Pump, Starter and Fuel PumpOpening of the Fan Cowl DoorsClosing of the Fan Cowl DoorsRemoval of the Fuel Pump and Filter AssemblyInstallation of the Fuel Pump and Filter AssemblyRemoval of the Pneumatic Starter
80-11-10-400-002 Installation of the Pneumatic Starter
72-63-00-991-305 72-63-00-991-306 Fig. 801Fig. 802
F 『 EEFF : ALL E Page 80372-63-00
E E May 01/05 ERE
ECES E
F 『
E C F M E
E E
E 56-5B E
E E
3. Job Set-up
__________ Subtask 72-63-00-941-058
A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a warning notice to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a warning notice to tell persons not to energize the FADEC 1(2).
Subtask 72-63-00-010-065
B. Open the fan cowl doors (Ref. TASK 71-13-00-010-040):
FOR 1000EM1
437AL, 438AR
FOR 1000EM2
447AL, 448AR
4. Procedure
_________ (Ref. Fig. 801/TASK 72-63-00-991-305, 802/TASK 72-63-00-991-306) Subtask 72-63-00-020-058
A. Preparation for the Removal of the Sealol Seal Assembly
(1) Depending on the drive pad on which you have to replace the sealol seal assembly, remove one of these units:
- fuel pump (Ref. TASK 73-11-10-000-003)
- hydraulic pump (Ref. TASK 29-11-51-000-041)
- IDG (Ref. TASK 24-21-51-000-040)
- starter (Ref. TASK 80-11-10-000-002)
F 『 EEFF : ALL E Page 80472-63-00
E E May 01/05 ERE
ECES E F 『 E C F M E E E E 56-5B E F 『 E C F M E E E E 56-5B E
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：A320飞机维护手册 AMM ENGINE 发动机 2(148)
