C. QEC Equipment
(1)
Accessory items installed on the engine are supplied by Boeing in the form of a QEC (Quick Engine Change) equipment kit. Procedures for installing this equipment are contained in this manual.
(2)
QEC kit parts are packaged in a series of sub-kits/tasks identified in the Special Spares Breakdown -Powerplant document issued by Customer Support, Spares. These sub-kit/task numbers are reflected in the figure numbers of 71-00-02 (see paragraph 4).
(3)
The following installations comprise the QEC kit:
Table 4:
INSTALLATION DWG NUMBER
ENGINE MOUNTS 310N3020 BRACKETS 332N3900 STARTER 332N3310
INTRODUCTION
Page 4 Jul 15/2009
(Continued)
INSTALLATION DWG NUMBER
STARTER VALVE 332N3310
STARTER DUCT 332N3310
TAI VALVE & DUCT 332N3380/332N3150
AVM 332N3420
HYDRAULIC PUMP 332N3120
FUEL & HYDRAULIC PLUMBING 332N3100
IDG 332N3240
IDG PLUMBING 332N3240/332N3150
OIL MARKER 310N3072
OIL INSTRUMENTATION 332N3450
FUEL FLOW XMTR 332N3460
DE OILER VENT 332N3730
14TH STAGE SURGE BLEED 332N3750
OVERBOARD DRAINS 332N3710/332N3150
HP PILOT CONTROLLER 332N3340
10TH & 14TH STAGE DUCTING 332N3320
FIRE/OVERHEAT DETECTOR 332N3500/332N3250
WIRE HARNESS 332N3220/332N3250
EXHAUST PLUG & SLEEVE 333N3000
INLET COWL 330N3010
4. Instructions for Using Manual
A. Page Numbering
(1)
Pages are numbered consecutively, starting with 1 in each of the subdivisions of the manual. The subdivision titles appear above the page number of each page.
(2)
Section 71-00-00 is subdivided into Introduction, Procedures Index, and Numerical Index. Section 71-00-01 is subdivided into individual figures of Accessory Assembly procedures. Section 71-00-02 is subdivided into individual figures of Powerplant Buildup procedures.
B. Figure and Item Numbers (71-00-01, 71-00-02)
(1)
Figure numbers are assigned to individual segments of buildup in order of accomplishment. Figures in 71-00-02, Powerplant Buildup, utilize a two-part number, the first part of which correlates to the QEC Sub-kit number in which the parts for that figure are supplied.
Exception is Figure 1-1 which is an index figure for 71-00-02.
(2)
Item numbers are assigned to parts, wherever possible, in order of installation. The part listing with item numbers and nomenclature appear on the text pages immediately following the applicable steps for installation of the parts. Each figure is a complete procedure and contain its individual set of item numbers.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：757 动力装置安装手册 Powerplant Buildup Manual(6)
