WinVIEWS can be sent via e-mail when an e-mail address is provided. In addition to the above software, a command file may be utilized. The command file is a simple text file that
includes each Current Value Table (CVT) Item used in a test procedure. The file must be ‘text only’ such as those created in the Microsoft Windows NotePad program. It should have a filename extension of .cmd. Once the file is loaded, WinVIEWS will display the current value of each CVT item listed in the file.
Typical WinVIEWS operation with the EGPWS:
1.
Connect the PC to the EGPWC via the appropriate RS-232 cable as defined above.
2.
On the PC, start Windows 3.1, or higher.
3.
Start the WinVIEWS.EXE program.
4.
WinVIEWS opens in the Terminal Mode. Various commands are available in this mode. Type “HELP” or “?” for command help. In particular, CVT Items may be added or deleted to/from the display to assist with system analysis.
5.
Under the File Menu select the “Load Command File” option and load the appropriate Command File.
6.
Use F6 to select the Display Mode: each CVT item listed in the Command File will be continuously updated at a rate of at least once per second. The value shown for each CVT Item listed is the current value used by the EGPWS. F6 toggles between the Display and Terminal Modes.
WinVIEWS Command File:
The format for a WinVIEWS command file is:
.
ASCII Text Only; no spaces
.
Each CVT Item must be typed exactly as specified
.
Each CVT Item Name is followed by a C/R <ENTER>
.
CVT Items list is available at www.egpws.com
