(b)
repetitive incidents and defects: monitor on a continuous basis defects occurring in flight and defects found during maintenance and overhaul, highlighting any that are repetitive.
(c)
deferred and carried forward defects: Monitor on a continuous basis deferred and carried forward defects. Deferred defects are defined as those defects reported in operational service which are deferred for later rectification. Carried forward defects are defined as those defects arising during maintenance which are carried forward for rectification at a later maintenance input.
(d)
unscheduled removals and system performance: analyse unscheduled component removals and the performance of aircraft systems for use as part of the maintenance programme efficiency.
When deferring or carrying forward a defect the cumulative effect of a number of deferred or carried forward defects occurring on the same aircraft and any restrictions contained in the MEL should be considered. Whenever possible, deferred defects should be made known to the pilot/flight crew prior to their arrival at the aircraft.
AMC M.A.301-3 Continuing airworthiness tasks
The owner or the M.A. Subpart G approved continuing airworthiness management organisation as applicable should have a system to ensure that all aircraft maintenance checks are performed within the limits prescribed by the approved aircraft maintenance programme and that, whenever a maintenance check cannot be performed within the required time limit, its postponement is allowed in accordance with a procedure agreed by the appropriate competent authority.
AMC M.A.301-4 Continuing airworthiness tasks
The operator or the contracted M.A. Subpart G approved organisation as applicable should have a system to analyse the effectiveness of the maintenance programme, with regard to spares, established defects, malfunctions and damage, and to amend the main-tenance programme accordingly.
AMC M.A.301-5 Continuing Airworthiness Tasks
Operational directives with a continuing airworthiness impact include operating rules such as extended twin-engine operations (ETOPS) / long range operations (LROPS), reduced vertical separation minima (RVSM), MNPS, all weather operations (AWOPS), RNAV, etc.
Any other continued airworthiness requirement made mandatory by the Agency includes TC related requirements such as: certification maintenance requirements (CMR), certifi-cation life limited parts, airworthiness limitations contained in CS-25 Book 1, Appendix H, paragraph H25.1, fuel tank system airworthiness limitations including Critical Design Configuration Control Limitations (CDCCL) etc.
AMC M.A.301-7 Continuing airworthiness tasks
An operator or a contracted M.A. Subpart G approved organisation as applicable should establish and work to a policy, which assesses non mandatory information related to the airworthiness of the aircraft. Non mandatory information such as service bulletins, service letters and other information that is produced for the aircraft and its components by an approved design organisation, the manufacturer, the competent authority or the Agency.
ED 2010/002/R ED 2009/006/R
Section A
PART-M
Subpart C
EC 1056/2008
M.A.302 Aircraft Maintenance programme
(a)
Maintenance of each aircraft shall be organised in accordance with an aircraft main-tenance programme.
(b)
The aircraft maintenance programme and any subsequent amendments shall be approved by the competent authority.
(c)
When the continuing airworthiness of the aircraft is managed by a continuing airwor-thiness management organisation approved in accordance with Section A, Subpart G of this Annex (Part M), the aircraft maintenance programme and its amendments may be approved through an indirect approval procedure.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：CONTINUING AIRWORTHINESS REQUIREMENTS – PART M 1(20)
