*
the maximum range between the positive and negative deviation values R(.) is not more than 10.
*
the difference between each magnetic heading value on the standby compass and the ND is not more than 8.. If the difference is more than 8., adjust the compensation
1EFF : ALL 1 34-22-00Page 511 1 1 Aug 01/05R 1 1 1CES 1
-write the actual compass heading Magnetic Heading (MH) + R(.) (Remaining deviation values). on the two correction cards. Put the cards on each side of the support of the standby compass.
5. Close-up
________
**ON A/C 001-049, 051-061, 101-105, 201-203,
Subtask 34-22-00-860-053
A. Put the aircraft back to its initial configuration.
(1)
Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
(2)
Do the ADIRS stop procedure (Ref. TASK 34-10-00-860-005).
(3)
Install the protection cover on the compensator.
(4)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
(5)
Put the aircraft back to the serviceable condition.
(6)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
Subtask 34-22-00-860-053-A
A. Put the aircraft back to its initial configuration.
(1)
Do the EIS stop procedure (Ref. TASK 31-60-00-860-002).
(2)
Do the ADIRS stop procedure (Ref. TASK 34-10-00-860-005).
(3)
De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-002).
(4)
Put the aircraft back to the serviceable condition.
(5)
Remove the ground support and maintenance equipment, the special and standard tools and all other items.
1EFF : ALL 1 34-22-00Page 512 1 1 Aug 01/05 1 1 1CES 1 COMPASS - STANDBY (2FN) - REMOVAL/INSTALLATION
______________________________________________
TASK 34-22-23-000-001
Removal of the Standby Compass (2FN)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking caps
No specific circuit breaker(s) safety clip(s)
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
**ON A/C 001-049, 051-061, 101-105, 201-203,
34-22-23-991-001 Fig. 401 R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
34-22-23-991-001-A Fig. 401A
1EFF : ALL 1 34-22-23Page 401 1 1 Aug 01/05 1 1 1CES 1 **ON A/C ALL
3. Job Set-up
__________
Subtask 34-22-23-865-053
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU LIGHTING/ICE AND STBY/COMP/LIGHT 1LF H04
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:A320飞机维护手册 AMM NAVIGATION 导航2(122)