• 热门标签

当前位置: 主页 > 航空资料 > 国外资料 > CAA >

时间:2011-08-28 16:23来源:蓝天飞行翻译 作者:航空
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

Cat I 30 μA (0.031 ddm) 8NM from the ILS reference datum to point A, then decreasing at a linear rateto 15 μA (0.015 ddm) at point B. 15 μA (0.015 ddm) from point B to point C (1204)Cat II / III30 μA (0.031 ddm) 8NM from the ILS reference datum to point A, then decreasing at a linear rate to 5 μA (0.005 ddm) at point B. 5 μA from point B to the ILS reference datum (1205).Course structure shall have a probability of 95% or better of not exceeding the limits given below,when assessed over a 40 second interval (1203).NOTE: Guidance on structure assessment may be found in Attachment C to ICAO Annex 10 Volume 1  Commissioning 1 or 2Annual 1 or 2Routine 1 or 2 
Identification  Clear and no perceptible interference to the basic localiser functions (1221)  Commissioning 1 & 2Annual 1 & 2Routine 1 & 2 
Power ratioTwo frequency systemsonly  On the localiser centreline, the course signal must exceed the clearance signal by a minimum of:Cat I /II 10 dB (2163).Cat III 16 dB (2164)  N/A  Commissioning 1 or 2Annual NoneRoutine None 

Parameter  Commissioning  Annual / Routine  Transmitter to bechecked 
Polarisation  Only required at the commissioning of an aerial system which is new to the UK.Polarisation error when the aircraft is in a roll attitude of 20° shall be no greater than:Cat I 0.016 ddm (1215).Cat II 0.008 ddm (1216).Cat III 0.005 ddm (1217).  As required 

Parameter  Commissioning  Annual/ Routine  Transmitter to be checked 
AlignmentOf the promulgatedglidepath angle  Cat I ± 1.5% (1910)Cat II ± 1.0% (1911)Cat III ± 1.0% (1912)  Cat I ± 7.5% (2173)Cat II ± 7.5% (2174)Cat III ± 4.0% (1915)  Commissioning 1 & 2Annual 1 & 2Routine 1 & 2 
Displacement SensitivityOf the nominal displacement sensitivity  Cat I ± 8% (1919)Cat II ± 6% (1920)Cat III ± 5% (1921)  Cat I ± 25% (1922)Cat II ± 20%(1923)Cat III ± 15% (1924)  Commissioning 1 & 2Annual 1 & 2Routine 1 & 2 
Symmetryof upper/lower half sector. Of the measureddisplacement sensitivity  Cat I 33% to 67%. (1928)Cat II 42% to 58%. (1929)Cat III 42% to 58%. (1930)  Commissioning 1 & 2Annual 1 & 2Routine 1 & 2 
Mod Sum SDMSum of the depths ofmodulation of the navigational tones  78% -82% Measured when approaching the facility, where the ddm is approximately zero (1931).  75% -85% Measured when approaching the facility, where the ddm is approximately zero (1932).  Commissioning 1 & 2Annual 1 & 2Routine 1 & 2 
Below Path ClearanceNormal Operations  The clearance below path should be measured close to the edge of the Designated Operational Coverage (DOC).There shall be a smooth increase in ddm from the glidepath angle to an anglewhere 190 μA fly-up (0.22 ddm) is reached. This shall occur at not less than 0.3θ (2165). Where this is achieved at an angle above 0.45θ, the fly-up must not fall below 190 μA (0.22 ddm)between this angle and 0.45θ or to such lower angle, down to 0.3θ, as required to safeguard the promulgated glidepath intercept procedure (2166).Where coverage between 0.45θ and 0.3θ is less than the specified datum, but sufficient current is present to remove the flag alarm, the fly-up shall not fall below 190μA (0.22 ddm) (1230).  Commissioning 1 & 2Annual 1 & 2Routine 1 & 2 

Parameter  Commissioning  Annual/ Routine  Transmitter to be checked 
Below Path ClearanceCourse onlyNote:This check is to ensurethat 2 frequency M- Arrays have beencorrectly set up and that the clearance transmitteris not hiding a problem  Cat IBetween the glidepath angle and 0.45θ or to such lower angle, down to 0.3θ, as required to safeguard the promulgated glidepath intercept procedure, the ddm must remain 150 Hzpredominant wherever a useable signal is present. (2167)Cat II / IIISmooth increase in ddm from the glidepath angleto an angle where 150 μA fly-up (0.175 ddm) is reached. Between this angle and 0.452 or to such lower angle, down to 0.3θ, as required tosafeguard the promulgated glidepath intercept procedure, the ddm must remain 150 Hzpredominant wherever a usable signal is present.(2168)Note: With clearance signal removed, there is norequirement to meet any coverage (signal strength) specification. Only the value of ddm is being examined.  N/A  Commissioning 1 or 2Annual NoneRoutine None 
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:CAP 670 Air Traffic Services Safety Requirements 2(37)