曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
on the cursor. Turn the large right knob to change between data fields. Turn the large or small right
knob to change a field that the cursor is on. Once you have made the desired selection, press the
ENT key to accept the entry.
The Configuration Pages described on the following pages are in the order found when rotating the
right small knob starting at the MAIN ARINC 429 CONFIG page.
Detail Steps/Work Items Key Items/References
(1) Select the following configuration on the MAIN
ARINC 429 page:
SPEED DATA
IN 1 Low Off
IN 2 Low Off
OUT Low Off
SDI Common
(2) Select the following configuration on the MAIN
RS232 CONFIG page:
INPUT OUTPUT
CHAN1 Icarus-alt Off
CHAN2 Off Off
CHAN3 Off Off
CHAN4 Off Off
FUEL TYPE AV gas
(3) No adjustments necessary on the MAIN INPUTS
1 and MAIN INPUTS 2 page.
AIRCRAFT
Communications DA 40 Series
AMM
Detail Steps/Work Items Key Items/References
Page 204
20 Sep 2007 23-10-00 Doc # 6.02.01
Rev. 5
(4) Select the following configuration on the MAIN
LIGHTING page:
DISPLAY KEY
LIGHTING --- ---
SOURCE PHOTO PHOTO
RESPONSE TIME 3 4
SLOPE 40 50
MINIMUM 250 40
OFFSET 40 50
(5) On the DATE/TIME SETUP page, it may be
desirable to set the date and time of the GNS 430
to aid in acquiring a GPS position.
Note that the time must be UTC time,
and that the UTC date may be different
from the date in the local time zone.
CAUTION: CHANGING TO THE WRONG UTC DATE/TIME WILL DELAY
SATELLITE ACQUISITION.
(6) No adjustments necessary on the MAIN
DISCRETE INPUTS page.
(7) No adjustments necessary on the MAIN
CDI/OBS CONFIG page except the SELECTED
COURSE.
Select 150° on the CDI that is connected to the
GNS 430 MAIN OBS inputs. The SELECTED
COURSE field should indicate near to 150° and a
'Calibrate to 150°?' field will appear. Selecting
this field will calibrate the GNS 430 to match the
input source.
Verify OBS operation by checking that
the course displayed on the GNS 430 is
within 2° of the selected course. Do this
at 30° intervals around the OBS card.
(8) Select the COM SETUP page. These values are
set at the factory and seldom require calibration.
FREQ
136.975 SQ 250 26
SPACING SQ 833 19
25.0 KHz SIDETN 63
FREQ
For purpose of setting the squelch and
sidetone levels, only the frequencies
118.000, 127.000, and 136.975 MHz
can be used.
SPACING
8.33 kHz channel spacing may be
required in some areas of the world.
AIRCRAFT
DA 40 Series
AMM
Communications
Detail Steps/Work Items Key Items/References
Doc # 6.02.01
Rev. 5 23-10-00 Page 205
20 Sep 2007
(9) No adjustments necessary on the VOR
DISCRETE INPUTS page.
(10) No adjustments necessary on the VOR/LOC/GS
CDI page.
(11) Select thr following configuration on the
VOR/LOC/GS ARINC 429 CONFIG page:
RX TX
SPEED Low Low
SDI VOR/ILS 1
DME MODE Directed freq 2
AIRCRAFT
Communications DA 40 Series
AMM
Page 206
20 Sep 2007 23-10-00 Doc # 6.02.01
Rev. 5
4. Configuration of the Garmin COM/NAV/GPS GNS 530
You must configure the unit after replacing it.
A. Configuration Mode Operation
With power applied to the avionic rack and the GNS 530 unit turned off, press and hold the ENT
key and turn the unit on. Release the ENT key when the display activates. After the data base
page, the first page displayed is the MAIN ARINC 429 CONFIG page. While in Configuration Mode,
pages can be selected by ensuring the cursor is off and rotating the small right knob.
To change data on the displayed Configuration Page, press the small right knob (CRSR) to turn
on the cursor. Turn the large right knob to change between data fields. Turn the large or small right
knob to change a field that the cursor is on. Once you have made the desired selection, press the
ENT key to accept the entry.
The Configuration Pages described on the following pages are in the order found when rotating the
right small knob starting at the MAIN ARINC 429 CONFIG page.
Detail Steps/Work Items Key Items/References
(1) Select the following configuration on the MAIN
ARINC 429 page:
SPEED DATA
IN 1 Low Off
IN 2 Low Off
OUT Low Off
SDI Common
(2) Select the following configuration on the MAIN
RS232 CONFIG page:
INPUT OUTPUT
CHAN1 Icarus-alt Off
CHAN2 Off Off
CHAN3 Off Off
CHAN4 Off Off
CHAN5 Off Off
CHAN6 Off Off
FUEL TYPE AV gas
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
钻石40系列AMM 1(96)
