曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% Figure 8: Battery Pack Installation - Artex ME 406 and ME 406 ACE
AIRCRAFT
DA 40 Series
AMM Equipment/Furnishings
Doc # 6.02.01
Rev. 5 25-60-00 Page 213
20 Sep 2007
% D. Artex C406-1
% You must change the battery pack on or before the battery replacement (expiration) date. You must
% replace the battery pack after a cumulative transmission time of one hour. You must replace the
% battery pack after use in an emergency. You must replace the battery pack after an inadvertent
% activation of unknown duration.
%
Detail Steps/Work Items Key Items/References
% NOTE: THE BATTERY PACK CONTAINS STATIC SENSITIVE PARTS, TAKE ESD
% PRECAUTION BEFORE HANDLING.
%
% (1) Remove the ELT from the airplane. Refer to Paragraph 2.
% (2) Remove the 4 retaining screws from the battery
% pack.
Refer to Figure 9.
% WARNING: THE BATTERY PACK IS CONNECTED TO THE ELT VIA SHORT
% INTERCONNECT HARNESS WHICH LIMIT THE DISTANCE OF SEPARATION
% BETWEEN THE TWO COMPONENTS PRIOR TO DISCONNECTING THE
% HARNESSES.
%
% (3) Lay the ELT on its side.
(4) Carefully lift the battery pack away from the ELT
% and lay alongside the ELT unit.
%
% (5) Carefully disconnect the harness from the 8-pin
% connector on the small circuit board in the battery
% pack.
Do not short connector pins.
% (6) Disconnect the 2-pin harness from the ELT body.
%
(7) Inspect the battery pack and the underside of the
% ELT. The battery cells, components and
% connectors should be free of corrosion. The
% underside of the ELT should be corrosion free.
% Inspect for any broken wires or connections.
% Ensure the battery housing is free of cracks or
% other visible damage.
% (8) When installing a new battery pack, remove the
% paper backing from the rubber seal at the
% connector end of the battery pack.
It is recommended that this seal be
coated with a non-petroleum based
silicon grease to provide a moisture
% resistant seal once the battery is
% installed.
AIRCRAFT
Equipment/Furnishings
DA 40 Series
AMM
Detail Steps/Work Items Key Items/References
Page 214
20 Sep 2007 25-60-00 Doc # 6.02.01
Rev. 5
%
(9) To install the battery pack, connect the 8-pin
% connector to the header on the circuit board in
% the battery pack.
% (10) Connect the 2-pin power harness to the ELT. This step will cause the ELT to activate.
% Reset the ELT by toggling the 'ON/OFF'
% switch on the ELT from 'ON' to 'OFF'.
%
(11) Fit the battery pack into place dressing wires
% away from the standoffs to avoid pinching wires
% between standoffs and battery pack.
% (12) Reinstall the 4 screws and tighten securely. Do not over torque the screws.
(13) Apply the new battery expiration date label
% provided with the battery pack to the exterior of
% the ELT (i.e. on the end cap or other visible
% location).
%
% (14) Reinstall the ELT into the mounting tray. Refer to Paragraph 2.
% (15) Do a functional test of the ELT. Refer to Paragraph 3.
AIRCRAFT
DA 40 Series
AMM Equipment/Furnishings
Doc # 6.02.01
Rev. 5 25-60-00 Page 215
20 Sep 2007
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
%
% Figure 9: Battery Pack Installation - Artex C 406-1
AIRCRAFT
Equipment/Furnishings
DA 40 Series
AMM
Page 216
20 Sep 2007 25-60-00 Doc # 6.02.01
Rev. 5
5. Remove/Install the RCPI
This paragraph is valid for the ACK E-01 ELT only.
A. Remove the RCPI
Detail Steps/Work Items Key Items/References
(1) Remove the instrument panel cover. Refer to Section 25-10.
(2) Disconnect the electrical cable from the rear of
the RCPI.
At the in-line connector.
(3) Remove the 4 screws which attach the RCPI to
the instrument panel.
(4) Move the RCPI forward and clear of the airplane.
B. Install the RCPI
Detail Steps/Work Items Key Items/References
(1) Move the RCPI into position in the instrument
panel.
(2) Install the 4 screws which attach the RCPI to the
instrument panel.
(3) Connect the electrical cable to the rear of the
RCPI.
At the in-line connector.
(4) Install the instrument panel cover. Refer to Section 25-10.
% (5) Do a functional test of the ELT system. Refer to Paragraph 3.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
钻石40系列AMM 1(147)
