SHOULD BE CHANGED IF SOLVENTS SPILLED ON THEM. PROTECTIVE EYE SHIELDS OR GOGGLES ARE TO BE WORN WHEN CLEANING WITH COMPRESSED AIR. DEBRIS AND/OR HIGH PRESSURE AIR CAN CAUSE SERIOUS EYE INJURY. PERSONNEL SHOULD BE WARNED OF AREAS WHERE HAZARDOUS MATERIALS OR PROCEDURES ARE IN USE.
CAUTION: DO NOT ALLOW CLEANING FLUIDS TO RUN INTO CONNECTORS, SWITCHES, TUBING COVERING WIRES OR ELECTRIC PANELS. USE ONLY RECOMMENDED CLEANING AGENTS OR EQUIVALENTS WITH SPECIFIC INSTRUCTIONS TO PREVENT DAMAGE TO THE DECORATIVE FINISHES AND TRIM. SMALL PARTS CAN EASILY BE DAMAGING BY HOLDING THE COMPRESSED AIR JET NOZZLE TOO CLOSE. USE BRUSHES CAREFULLY ON DELICATE PARTS.
A. Table Assembly
(1)
Cleaning
(a)
Remove stubborn dirt with a solution of 1.25 grams of Super Soilax detergent (or equivalent) per gallon of hot water.
(b)
After cleaning completely, use hot water and a clean, soft cloth to wipe all surfaces.
(c)
Towel dry with a clean, lint-free cloth.
(2)
Remove Corrosion
(a)
Use a cloth saturated in a liquid solution of 50% distilled water and 50% corrosion-removing compound.
(b)
Flush the treated area thoroughly with warm, potable water.
(c)
Dry with compressed air.
(d)
Mark all areas cleaned for corrosion in this manner for inspection per the CHECK procedure and treatment as specified in REPAIR.
(3) Disinfect
(a)
Wash in a solution of five (5) tablespoons of liquid disinfectant (Lysol or equivalent) to each gallon distilled.
(b)
Rinse for five (5) minutes in running water.
(c)
Blow dry with compressed air and/or wipe clean with a lint-free cloth.
B. Structure Assembly
CAUTION: STRUCTURE ASSEMBLIES ARE FABRICATED FROM A MULTI-PLY HONEYCOMB PANEL. DO NOT EMPLOY CLEANING PROCEDURES OUTLINED FOR METAL PARTS (SUCH AS FITTINGS, ANGLES, ETC) OR DAMAGED TO THE DECORATIVE FINISH OF THE HONEYCOMB PANELING MAY RESULT.
(1)
Clean Panels
(a)
Remove dirt, grease and oil deposits from paneling with a clean cloth saturated in Isopropyl or Ethanol Alcohol.
(b)
Stubborn stains may be cleaned with abrasive cleaning agents, such as household scouring powder (ammoniated or chlorinated) in combination with a dampened cloth. Use with care to avoid damaging decorative surfaces. Do not use any type of abrasive scouring pad.
(c)
Remove difficult scuffs and/or stains from surfaces which appear metallic using an appropriate cleaning solvent.
(d)
Remove solvent using a soft, lint-free cloth soaked in Rho-clene. Stubborn residue may removed with Kleenol-30.
(2)
Clean Metal Parts
(a)
Remove dirt, grease and oil from metal structural parts with a clean cloth saturated with Toluene, Benzene or Xylene cleaning solvent.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757-200 LH RH CLASS DIVIDER(16)
