b) Press self adhesive decorative to the surface with finger pressure.
c) Squeeze the self adhesive decorative into place with firm, overlapping strokes across the width of the material while removing the remainder of the liner a few inches at a time to prevent pre-adhesion.
3) Top Horizontal Hinge Method (Decorative Area larger than 4 sq. ft.)
a) Leave the liner on the self adhesive decorative.
b) Tape the decorative material into position with small pieces of masking tape. Apply 2"-3" tape over the top edge to serve as a hinge.
c) Make a cut about half-way through the tape hinge at both ends.
d) Raise the decorative up over the top hinge and peel the liner back a few inches at a time, while squeegee the surface with firm, overlapping strokes, beginning at the top center and working down and outward toward each edge.
e) Hold the decorative away from the surface with one hand and allow the adhesive to touch only as pressure is applied.
f) Squeegee the edges.
4) Center Hinge Method (Decorative Larger than 4 sq. ft.)
a) Leave the liner on the self adhesive decorative.
b) Tape the decorative material into position with small pieces of masking tape. Apply 1" or 2" tape hinge through the center of the decorative material, either vertically or horizontally.
c) Fold half the decorative material back over the hinge, peel the liner off of the decorative material (back to the tape hinge), cut the liner along the hinge and discard.
d) Fold the decorative material back down and squeegee the surface beginning at the center from the hinge and work outward and away from the tape hinge using firm, overlapping strokes.
e) Hold away from the surface with one hand and allow the adhesive to touch only as pressure is applied.
f) Remove the tape hinge.
g) Fold over half of the film, remove the liner and apply as above.
PAGE 6007
THIS PAGE INTENTIONALLY LEFT BLANK
ASSEMBLY
1. General
The unit is an integrally bonded structure which is fabricated from sandwich panels and aluminum extrusions. During assembly, it is recommended that low cost items, such as cotter pins, screws, washers, nuts, grommets, etc., be replaced when possible to prevent future maintenance requirements due to failure of such items. It is essential when replacing components, that they be identical to the items being replaced. If component substitutions are being considered, Bolder Manufacturing must be notified.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757-200 LH RH CLASS DIVIDER(10)
