2. Installation
A. Unit Installation
NOTE: CAREFULLY INSPECT ALL RIVETED, SPOT WELDED, OR BONDED ASSEMBLIES AND COMPONENTS PRIOR TO INSTALLATION/ASSEMBLY. DO NOT REMOVE THESE ITEMS UNLESS REQUIRED DUE TO DAMAGE OR OTHER NEED FOR REPLACEMENT.
CAUTION: EXERCISE EXTREME CARE WHEN REMOVING SCREWS OR BOLTS THAT ATTACH A PART TO THE SYNTHETIC PANELING. THREADED INSERTS, WHICH ARE INSTALLED IN THE PANELING TO RECEIVE SCREWS OR BOLTS, ARE INSTALLED IN PANELING WITH POTTING COMPOUND. UNNECESSARY DAMAGE TO THESE INSERTS WILL REQUIRE REPLACEMENT WITH LARGER INSERTS.
(1)
Position the unit in between the following coordinates:
(2)
Follow installation instructions described on figure 13001, pages 13003 thru 13006.
(For -501 LH) STA =567.45, LBL = 14.00 (For -502 RH) STA =567.45, RBL = 14.00
PAGE 13001
THIS PAGE INTENTIONALLY LEFT BLANK
SERVICING
1.
General
The unit must be serviced before it is checked or repaired. Servicing will restore the unit performance and appearance.
2.
Servicing Materials
Only use recommended servicing agents and materials (or appropriate equivalents). Take care to comply with all cautions and warnings.
Equivalent substitutes may be used for listed items.
WARNING: SOME AGENTS AND MATERIALS CAN BE DETRIMENTAL TO DECORATIVE TRIMS AND/OR FINISHES, AS WELL AS HARMFUL TO PERSONNEL, IF HANDED IMPROPERLY.
TABLE 14001
RECOMMENDED SERVICING AGENTS AND MATERIALS
Material Identification Source
Air, compressed Brushes, small soft bristled Brushes, non metallic Cloth, Lint Free Compound, corrosion removing Detergent, commercial Desinfectant Isopropyl Alcohol ----MIL-C-38334 Super Soilax or Electro Sol Lysol Federal Specification TT-I-735 Any approved source Commercially available Commercially available Commercially available Commercially available Commercially available Commercially available Commercially available
3. Servicing While Disassembled
Perform these steps at any time the Divider is disassembled, partial or complete over haul of the unit performed. Areas not normally exposed are to be thoroughly cleaned and sanitized at this time.
WARNING: AVOID BREATHING THE VAPORS OR FUMES FROM ANY CLEANING SOLVENT. GOGGLES, GLOVES, A MASK AND PROTECTIVE CLOTHING ARE TO BE WORN TO PREVENT IRRITATION FROM PROLONGED CONTACT WITH CLEANING AGENTS. CLOTHES
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757-200 LH RH CLASS DIVIDER(15)