• 热门标签

当前位置: 主页 > 航空资料 > 飞行资料 >

时间:2011-03-14 17:06来源:蓝天飞行翻译 作者:admin
曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

At lift–off:
.  
the pitch command continues at 15 degrees until sufficient climb rate is acquired. Pitch then commands MCP speed (normally V2) plus 20 knots

.  
if an engine failure occurs during takeoff, the pitch command target speed is:

.  
V2, if airspeed is below V2

.  
existing speed, if airspeed is between V2 and V2 + 20

.
V2 + 20, if airspeed is above V2 + 20
YA686, YA687


.  
the roll command maintains wings level.
YA613, YA626, YA721 - YK104


.  
the roll command maintains HDG SEL. Bank angle is limited to 8 degrees below 400 feet, and 10–30 degrees selectable above 400 feet AGL.


After lift–off:
.  
the A/T remains in THR HLD until 800 feet RA. A/T annunciation then changes from THR HLD to ARM and reduction to climb thrust can be made by pushing the N1 switch

YA721 - YC413, YK101 - YK104

.  
automatic thrust reduction to climb power occurs when VNAV, ALT ACQ or ALT HOLD is engaged. Until 2 1/2 minutes after liftoff, automatic thrust reduction is inhibited when engaging LVL CHG or V/S modes

YA613 - YA687, YD651 - YD655

.  
automatic reduction to climb thrust occurs upon reaching the selected thrust reduction altitude which is shown on the FMC CDU TAKEOFF REF page 2/2 during preflight, or when the airplane levels off in ALT HOLD or VNAV PTH. Pilot entries can be made to override the default value. Allowable entries are 800 feet to 9999 feet

.  
flight director engaged status is terminated by engaging an autopilot in
CMD (CMD replaces FD in A/P status display)


.  
pitch engages in LVL CHG and pitch mode FMA is MCP SPD unless another pitch mode has been selected

.  
MCP IAS/Mach display and airspeed cursor change to V2 + 20 knots


Copyright . The Boeing Company. See title page for details.
4.20.10   September 29, 2005

Automatic Flight -System Description

. roll mode engages in HDG SEL unless another roll mode has been
selected. To terminate the takeoff mode below 400 feet RA, both F/D switches must be turned OFF. Above 400 feet RA, selection of another pitch mode or engaging an autopilot will terminate the takeoff mode; other F/D roll modes can be also selected.
Automatic Flight Takeoff Profile
YA686, YA687

Copyright . The Boeing Company. See title page for details.
September 29, 2005  4.20.11
Automatic Flight -System Description

YA613, YA626, YA721 - YK104

Engage A/P
.
A/P engages in CMD

.
 Pitch mode
   engages in
 MCP SPD

 

Thrust Reduction
 . A/T N1 mode
 engages at
 CLB power


800 ft RA –
. A/T ARM   mode engages

84 knots –
 . A/T THR HLD mode   engages
Push TO/GASwitch
(both FD ON and A/T armed)
Automatic Flight En Route
The autopilot and/or the flight director can be used after takeoff to fly a lateral navigation track (LNAV) and a vertical navigation track (VNAV) provided by the FMC.
Other roll modes available are:
.
VOR course (VOR/LOC)

.
heading select (HDG SEL). Other pitch modes available are:

.
altitude hold (ALT HOLD)

.
level change (MCP SPD)

.
vertical speed (V/S).


Copyright . The Boeing Company. See title page for details.
4.20.12  March 28, 2005

Automatic Flight -System Description 737 Flight Crew Operations Manual
Automatic Flight Approach and Landing
The AFDS provides guidance for single A/P non–precision approaches. The VOR/LOC switch arms the AFDS for VOR or localizer tracking. Descent may be accomplished using VNAV, LVL CHG, or V/S. VOR/LOC, LNAV, or HDG SEL may be used for the roll mode.
The AFDS provides guidance for single or dual A/P precision approaches. The approach mode arms the AFDS to capture and track the localizer and glideslope.
Approach (APP) Mode Dual A/Ps
Approach mode allows both A/Ps to be engaged at the same time. Dual A/P operation provides fail–passive operation through landing flare and touchdown or an automatic go–around. During fail passive operation, the flight controls respond to the A/P commanding the lesser control movement. If a failure occurs in one A/P, the failed channel is counteracted by the second channel such that both A/Ps disconnect with minimal airplane maneuvering and with aural and visual warnings to the pilot.
One VHF NAV receiver must be tuned to an ILS frequency before the approach mode can be selected. For a dual A/P approach, the second VHF NAV receiver must be tuned to the ILS frequency and the corresponding A/P engaged in CMD prior to 800 feet RA.
 
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址:737NG机组操作手册Flight Crew Operations Manual FCOM 2(91)