曝光台 注意防骗
网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者
GROUND ANCHOR-POINTS
(3) Attach a rope to each mooring point and to the
ground anchor point.
Do not make the ropes tight.
(4) Remove all items that may damage the airplane.
Parking, Mooring, Storage
and Return to Service
DA20-C1 AMM
Page 2
19 Dec 1997 10-20-00 Doc # DA 201-C1
Rev. 0
Figure 1: Location of Mooring Points on the Airplane
DA20-C1 AMM
Parking, Mooring, Storage
and Return to Service
Doc # DA 201-C1
Rev. 0 10-30-00 Page 1
19 Dec 1997
CHAPTER 10-30
RETURN TO SERVICE
1. General
Do this procedure when the airplane has been parked (or stored) for more than 5 days.
2. Return to Service Procedure
Detail Steps/Work Items Key Items
(1) Do the procedure for Returning Engine to Service. Refer to the Operator and Installation
Manual for the Continental IO-240-B.
(2) If necessary, install loose equipment which was
removed for storage.
(3) If the battery has been removed.
− Install the airplane battery.
Refer to Chapter 24-31.
Parking, Mooring, Storage
and Return to Service
DA20-C1 AMM
Page 2
19 Dec 1997 10-30-00 Doc # DA 201-C1
Rev. 0
Intentionally left blank
DA20-C1 AMM
Placards and Markings
Doc # DA201-C1
Rev. 0 11-TITLE Page 1
19 Dec 1997
CHAPTER 11
PLACARDS AND MARKINGS
Placards and Markings
DA20-C1 AMM
Page 2
19 Dec 1997 11-TITLE Doc # DA201-C1
Rev. 0
Intentionally left blank
DA20-C1 AMM
Placards and Markings
Doc # DA201-C1
Rev. 0 11-CONTENTS Page 1
19 Dec 1997
TABLE OF CONTENTS
CHAPTER 11-00 GENERAL.....................................................................................................................1
1. General .....................................................................................................................1
2. Replace Plastic Foil Placards ...................................................................................1
CHAPTER 11-20 EXTERIOR PLACARDS AND MARKINGS..................................................................1
1. General .....................................................................................................................1
CHAPTER 11-30 INTERIOR PLACARDS AND MARKINGS ...................................................................1
1. General .....................................................................................................................1
Placards and Markings
DA20-C1 AMM
Page 2
19 Dec 1997 11-CONTENTS Doc # DA201-C1
Rev. 0
Intentionally left blank
DA20-C1 AMM
Placards and Markings
Doc # DA201-C1
Rev. 0 11-00-00 Page 1
19 Dec 1997
CHAPTER 11-00
GENERAL
1. General
Placards are used for identification and indication. They show the function, operation and operating
limitations of systems and equipment.
This Chapter shows you the location of the exterior placards and markings. It also shows you the
location of the interior placards.
Self-adhesive plastic foil is used for all placards except for the metal manufacturers placard located
on the skid-plate.
Replace damaged placards.
2. Replace Plastic Foil Placards
A. Material
Item Quantity Reference
Solvent A/R Commercial
B. Replace a Placard
Detail Steps/Work Items Key Items
(1) Remove the old placard:
− Heat the placard with a hot air blower.
− Lift one corner of the placard.
− Pull the placard off.
WARNING: DO NOT GET SOLVENT ON YOUR SKIN. DO NOT BREATH
SOLVENT VAPOR. SOLVENT CAN CAUSE DISEASE OR ILLNESS
(2) Clean the surface where the new placard will
go.
Use a commercial solvent.
There must be no dirt or oil on the surface.
(3) Remove the protective backing from the new
placard.
(4) Put the new placard in the correct position.
Placards and Markings
DA20-C1 AMM
Page 2
19 Dec 1997 11-00-00 Doc # DA201-C1
Rev. 0
Intentionally left blank
DA20-C1 AMM
Placards and Markings
Doc # DA201-C1
Rev. 9 11-20-00 Page 1
29 Apr 2004
CHAPTER 11-20
EXTERIOR PLACARDS AND MARKINGS
1. General
The DA20-C1 has these exterior placards:
Figure 1: General Exterior Placards
93 L/24.5 US gal. AVGAS 100LL
USABLE 91 L/ 24.0 US gal
78L/20.5 US gal. AVGAS 100LL
USABLE 76 L/20.0 US gal.
2.3 bar
33 psi
230 kPa
1.8 bar
26 psi
180 kPa
DiamondAIRCRAFT
INDUSTRIES
LONDON, ONTARIO, CANADA
MODEL NO. : DA20-C1
SERIAL NO. :
DATE MFD. :
TYPE CERT. : CAN A-191
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：
钻石20系列AMM 1(47)
