CFM 56-3 Engine Disassembly and Assembly Capability(7)

.  Installation of Oil Pressure Transmitter

.  Installation of Low Oil Pressure Warning Switch

.  Installation of Oil Filter Differential Pressure Switch and Oil Temperature Sensor

.  Installation of Oil Quantity Transmitter

.  Installation of Engine Throttle Fuel Control Box

.  Installation of Primary Exhaust Sleeve and Exhaust Plug

.  Installation of CSD/AC Generator Cooling Air Duct and CSD & AC Generator; Installation of VSCF Generator/Converter Cooling Air Duct and VSCF Generator/Converter

.  Installation of VSCF Generator/Converter Oil Cooler Plumbing and VSCF Generator/Converter Oil Cooler; Installation of CSD Oil Cooler Plumbing and CSD Oil Cooler

.  Installation of Hydraulic Pump and Hydraulic Plumbing

.  Installation of Starter, Starter Valve and Duct System

.  Installation of Inlet Cowl Thermal Anti-ice System/Installation of Forward TAI Duct

.  Installation of PPBU Electrical Components of Core Module

.  Installation of PPBU Electrical Components of Fan

.  Preliminary Inspection

.  Preparation of Fan Major Module for Installation ofTGB

.  Installation of ABG

.  Installation of CIT T25 Sensor, Timer, Electro-valve and Hardware

.  Installation of Piping and Hardware between Core & Fan Module

.  Adjustment and Rigging of VBV and VSV Cable

.  Installation of Tubes on Fan Module

.  Installation of Core Hardware

.  Installation of HPT Nozzle Module – Horizontal Position

.  Installation of HPT Rotor Module – Horizontal Position

.  Installation of HPT Shroud and Stage 1 LPT Nozzle Assembly

.  Installation of LPT Major Module

.  Installation of additional Parts of LPT Major Module

.  Installation of Spinner Rear and Front Cone

.  Installation of LPT Air Cooling Tubes & Manifold Assemblies

.  Installation of PMC, Electrical Harness, Temperature Sensors & Chip Detectors

.  Installation of Aft Sump Oil Supply & Scavenge Tubes & No.5 Bearing Vibration Monitoring Kit

.  Installation of T4.95 Wiring Harness

.  Complete the List of Complaints

.  Preliminary Inspection

.  Installation of Air/Oil Drain Tube

.  Installation of IGB & No.3 Bearing Assembly

.  Installation of Forward Stationary Oil Seal

.  Installation of Rear Stationary Oil Seal

.  Prepare for Installation of No.1 & No.2 Bearing Support Assembly

.  Installation of No.1 Bearing Vibration Sensor on No.1 Bearing Support

.  Installation of No.1 and No.2 Bearing Support Assembly

.  Installation of No.1 Bearing Vibration Sensor in Fan Frame
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：CFM 56-3 Engine Disassembly and Assembly Capability(7)