To view this page ensure that Adobe Flash Player version 9.0.124 or greater is installed.
. Remove HPT Rear Shaft
. Remove HPT Front Shaft
. Remove HPT Front Seal
. Remove Front Blade Retainer
. Visually Inspect exposed areas of Sub-assemblies
Disassembly
. Incoming Inspection
. Remove Slabbed-Head Bolts from HPT Shroud Nozzle Support Forward Flange
. Remove LPT Nozzle Assembly from HPT Shroud Support Assembly
. Disassemble HPT Shroud
. Visually Inspect exposed areas of Sub-assemblies
. Incoming Inspection
. Disassembly of Rotor/Stator
. Removal of LPT Shroud Support
. Disassembly of Stage 4 Turbine Disk
. Disassembly of Stage 3 Turbine Disk
. Disassembly of Stage 2 Turbine Disk
. Disassembly of Stage 1 Turbine Disk
. Disassembly of Turbine Air Cooling Air Tube Assembly
. Visually Inspect exposed areas of Sub-assemblies
. Incoming Inspection
. Removal of No.5 Roller Bearing
. Removal of Center Vent Tube Rear Extension Duct
. Removal of Center Vent Tube
. Removal of Center Vent Tube Supports
. Removal of Rear Rotating Air/Oil Seal and Rear Rotating Air Seal
. Removal of Forward Rotating Air Seal
. Removal of LPT Stub Shaft
. Removal of Forward Rotating Oil Seal
. Removal of No.4 Roller Bearing
. Install LPT Shaft in Storage Position
. Install overall protective items on Forward and Aft Ends of LPT Shaft
. Visually Inspect exposed areas of Sub-assemblies
. Incoming Inspection
. Removal of Turbine Frame Midstream Fairing and Rear Cover
. Removal of Blanking Plugs mounted externally around Turbine Frame
. Removal of No.5 Bearing Overboard Seal Drain Tube
. Removal of No.5 Bearing Overboard Seal Drain Flange
. Removal of Clamp and Support Securing No.5 Bearing Oil Supply Tube from Turbine Frame
. Removal of No.5 Bearing Adjusting Sleeve
. Removal of No.5 Bearing Support and Oil Sump Assembly
. Visually Inspect exposed areas of Sub-assemblies
. Incoming Inspection
. Remove No.3 Bearing Front Oil Nozzle
. Remove Radial Drive Shaft Oil Nozzle
. Remove No.3 Bearing Retaining Bolt
. Remove No.3 Bearing Aft Oil Nozzle
. Remove Horizontal Bevel Gear Assembly
. Remove No.3 Bearing Aft Rotating Seal
. Remove No.3 Bearing from Horizontal Bevel Gear
. Remove No.3 Bearing Lock Nut from Horizontal Bevel Gear
. Disassemble No.3 Bearing Lock Nut
. Remove Radial Bevel Gear from IBG Housing
中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址:CFM 56-3 Engine Disassembly and Assembly Capability(5)