To view this page ensure that Adobe Flash Player version 9.0.124 or greater is installed.
.
Visually Inspect exposed areas
Front Stator Assembly (Configuration One)
Edited by Li CFM56-3 Engine Disassembly and Assembly Capability -11 -Hao
.
Removal of NMP’s for LPT Module Removal
.
Removal of NMP’s for Core Module Removal
.
Incoming Inspection
.
Remove Stage 4 Vane Assembly
.
Remove Stage 1 Vane Assembly
.
Separate Fan Disk from Booster Spool
.
Remove Parts from Booster Spool
.
Remove Aft Blade Retainer
.
Visually Inspect exposed areas of Module
. Incoming Inspection
. Remove No.1 Bearing Oil Scavenge, Air Pressure and Drain Tubes
. Disassemble No.2 Bearing Support Assembly
. Remove No.1 Bearing Oil Manifold and No.1 & No.2 Bearing Oil Supply Tube Assembly
. Remove No.2 Bearing Air/Oil Retaining Seal
. Remove Inner Race of No.2 Bearing
. Remove N1 Speed Sensor Ring
. Remove Rotating Air/Oil Separator Retaining Nut
. Remove Rotating Air/Oil Separator
. Remove No.1 Bearing Inner Race Retaining Nut
. Remove No.1 Bearing Support Assembly
. Disassemble No.1 Bearing Support Assembly
. Disassemble No.1 Bearing Housing Assembly
. Remove No.1 Bearing Sleeve
. Remove Fan Shaft from Assembly/Disassembly Support
. Incoming Inspection
. Remove External Tubing and Clamps
. Remove Oil Tank
. Remove Oil Tank Bracket Assemblies
. Remove PS12 Air Instrumentation Nipples
. Remove 2 Drain Nipples on Fan Inlet Case
. Remove Fan Case Forward Acoustical Panels
. Remove Mid Acoustical Panel Assemblies
. Remove Fan Outlet Guide Vanes
. Remove Fan Frame Aft Acoustical Panel Assemblies
. Remove Fan Duct Panels
. Remove OGV Fairing Assembly
. Remove VBV System Components
. Remove Igniter Lead Cooling Air Elbow &Blanking Parts from VBV Cavity
. Remove Flexible Shaft Ferrules
. Remove No.1 Vibration Sensor Rear Guide Tube
. Remove Blanking Plates
. Remove AGB Mount Links
. Remove Right and Left Ground Handling MountPins
. Remove Brackets from Flanges of Fan FrameAssembly
. Separate Inlet Case from Fan Frame
. Remove Fan Frame Strut Internal & External
. Incoming Inspection
. Remove Stage 1 Blades
. Remove Stage 2 Blades
. Remove Stage 3 Blades
. Remove Stage 4 Blades
. Remove Stages 5 through 9 Blades
. Remove and discard Seal Wires from Stage 4 through 9 中国航空网 www.aero.cn 航空翻译 www.aviation.cn 本文链接地址:CFM 56-3 Engine Disassembly and Assembly Capability(3)