777 AMM 飞机维护手册 发动机和燃油控制 Engine Fuel and Control PW 777 AIRCRAFT MAINTENANCE MANUAL(23)

曝光台 注意防骗 网曝天猫店富美金盛家居专营店坑蒙拐骗欺诈消费者

In NORM, the switch lets EEC power come from normal operating power sources. In TEST, the switch connects airplane ac power to the EEC without starting any EEC control logic. It also sends a ground test discrete signal to the AIMS.
EEC Mode Switch
The EEC mode switch is on the engine start/ignition panel on the P5 overhead panel. The switch is a two-position, guarded, alternate-action switch.
The switch lets the pilots set the EEC control mode. You should always operate the engines in the same control mode.
EFFECTIVITY
BEJ ALL

CAUTION:  DO NOT MOVE THE EEC MODE SWITCH FROM NORM TO ALTN WHEN THE ENGINE IS OPERATING AT HIGH POWER. THE ENGINE MAY OVERBOOST IF YOU DO.
Normal Mode (EPR)
The normal position of the switch is on (in). This shows a mechanical indication of NORM. This position puts the EEC into its normal (EPR) mode. EPR is the thrust rating parameter for the engine.
In the EPR mode, the EEC uses this data to set the proper thrust:
*
Thrust lever angle (TLA)

*
Inlet temperature

*
Altitude

*
Mach number

*
Bleed status.

You can set thrust with the thrust levers at specified positions. There are specific thrust lever positions for takeoff, maximum continuous, and maximum climb thrust ratings. There is a linear EPR relationship between these thrust lever rating positions and idle.
73-21-00

Page 55 D633W101-BEJ Sep 05/2002

ENGINE FUEL CONTROL -OPERATION

Alternate Mode (N1)
The non-normal position of the switch is out. This hides NORM and shows a lighted ALTN. When the switch is out, the EEC is in alternate (N1) mode. The EPR indication goes out of view when the EEC is in the alternate mode.
In the alternate mode, the EEC controls the engine with N1 speed. It uses this data to adjust the engine N1:
*
TLA

*
Inlet temperature

*
Altitude.

In alternate mode with the thrust levers at a specific position, the thrust changes as the flight conditions change. It is necessary to adjust the thrust levers as the airplane flies in order to maintain the correct thrust.
Some faults make the EEC change to the alternate mode automatically. When this happens, the EEC turns on the ALTN light in the EEC mode switch.
The EEC uses the alternate mode during reverse thrust operation. This is because EPR is not accurate when the engine is in reverse thrust.
Thrust Lever
The thrust levers move TLA resolvers. The resolver sends angle position to the EEC. This signal lets the EEC set the proper thrust.
See the engine controls chapter for more information about the thrust levers and resolvers (CHAPTER 76).
Fuel Control Switch
The fuel control switches have two positions: RUN and CUTOFF. In RUN, the switch sends signals to the EEC to enable fuel flow. The EEC makes the decision when to start fuel flow. In CUTOFF, the switch controls the FMU to shut off metered fuel flow to the injectors. It also closes the engine fuel spar valve.
　
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：777 AMM 飞机维护手册 发动机和燃油控制 Engine Fuel and Control PW 777 AIRCRAFT MAINTENANCE MANUAL(23)