If your airline did not select any software options, your code is -000000000000.
January 1, 2004
34-61
- 30 -
SOUTHWEST AIRLINES PROPRIETARY(c) All rights reserved
A34-61-00-064.fm
SOUTHWEST AIRLINES.
737-700 MAINTENANCE TRAINING MANUAL
-
THESE ARE EXAMPLES OF SOFTWARE OPTIONS AND MIGHT NOT REPRESENT THE OPTIONS ON YOUR AIRPLANE(S).
FMCS BITE PAGES - SOFTWARE OPTIONS
January 1, 2004
34-61
SOUTHWEST AIRLINES PROPRIETARY(c) All rights reserved
SOUTHWEST AIRLINES.
737-700 MAINTENANCE TRAINING MANUAL
FMCS BITE PAGES - PERFORMANCE FACTORS THIS PAGE INTENTIONALLY LEFT BLANK
January 1, 2004
34-61
- 32 -
SOUTHWEST AIRLINES PROPRIETARY(c) All rights reserved
SOUTHWEST AIRLINES.
737-700 MAINTENANCE TRAINING MANUAL
FMCS BITE PAGES - PERFORMANCE FACTORS Purpose
The performance factors page permits the display and entry of performance factors to optimize airplane performance for individual operators or airplane characteristics.
Page Access
You use the PERF FACTR line select key (3R) on the FMCS BITE page to get access to the performance factors page.
This page will automatically show if there is a performance factors mismatch during power-up and it is the only mismatch.
Performance Factors Page
The aerodynamic and engine models in the performance data base are from airplane design and flight test data. Since each production airplane may be different, the FMCS PERF FACTORS page lets the operator make adjustments for some of the factors in the model/engine database.
If the two FMCs do not agree on the value for a performance factor, the factor is highlighted. In the example shown on the graphic, FMC 2 does not agree with the value for the engine out minimum rate of climb.
Line select key 2L shows the DRAG FACTOR value. This is a correction factor applied to drag calculations and is a percentage. The default value is 0.0 and the allowable entry range is - 9.9 to + 9.9
Line select key 3L shows the fuel flow (F-F) value. This is a correction factor applied to fuel flow calculations and is a percentage. The default value is 0.0 and the allowable entry range is -9.9 to + 9.9.
Line select key 4L shows the maneuver margin (MNVR MARGIN) value. The maneuver margin is used for flight envelope and bank angle calculations. The default value is 1.3g and the allowable entry range is 1.2g to 1.6g.
Line select key 5L shows the minimum cruise time (MIN CRZ TIME) value in minutes. This value is a lower limit to the minimum cruise time from the performance data base for trip altitude calculations. The default value is 1.0 and the allowable entry range is 1.0 to 20.
Line select key 6L shows the INDEX prompt. This selects the FMCS BITE page.
中国航空网 www.aero.cn
航空翻译 www.aviation.cn
本文链接地址：737-700 MAINTENANCE TRAINING MANUAL BITE HANDBOOK 机务培训手册 自测手册(17)
